Tie Rod End for 2019-2022 Toyota Corolla & More - Delphi TA3275

Delphi TA3275 tie rod end for the 2019-2022 Toyota Corolla and other vehicles connects the steering linkage to the wheel's steering knuckle. It draws on the OE expertise behind Delphi's safety technology, which is fitted to millions of vehicles worldwide.

• Tested to withstand temperatures below -40 degrees C and over 120 degrees C and 720 hours of salt spray.
• Dimensional and material analysis supports compatibility between this part and the OE part.
• The necessary accessories for a complete job are included.
• Ball studs are machined to micron tolerances for durability and smooth joint operation.
• Delphi tie rods are fatigue tested to avoid failure.
• Anti-corrosion protection is applied to each part to prevent corrosion and give a better finish.

A worn tie rod end can show up as loose steering, a wander at highway speed or uneven tire wear. Worn ball joints, control arm bushings or wheel bearings can be behind the same signs, so find the cause before you buy. This listing is one right outer piece, and the left side is normally replaced at the same time.

As a direct-fit replacement steering tie rod end, it also fits the 2016-2022 Toyota Prius and the 2017-2022 Toyota Prius Prime, one per vehicle. Driving something else? Enter your car in the "Vehicles it fits" section to see whether it is covered.

Specifications

• Position: Right outer
• Quantity per vehicle: 1

Interchange: 101-8176 · 45046-49255 · 45046-F9010
TO74372 · TO74372PR · ES801549 · MS86661