Help keep your rear suspension tight and predictable with the Delphi ball joint, part number TC2133. This rear lower ball joint pivots the suspension while locating the wheel, and it drops in as a direct-fit replacement for several Mercedes-Benz models, among them the 2003-2005 Mercedes-Benz ML350, 2002-2005 Mercedes-Benz ML500 and 1998-2003 Mercedes-Benz ML320. See the Buyer's Guide tab for the full list and engine-level fitment.
Delphi applies its OE expertise to this aftermarket joint, testing to extremes — from below -40°C to over 120°C and through 720 hours of salt spray — with extensive dimensional and material analysis for close OE compatibility.
Signs this rear lower ball joint may need replacing include clunking from the rear suspension, looseness, or uneven tire wear. If a worn ball joint is the cause, this replaces it — diagnose the root cause before installing.
Interchange: 101-7334 · MB-G125 · 163 350 00 13 · 163 350 01 13 · A163 350 0013 · A163 350 0113
1017334 · MBG125 · 1633500013 · 1633500113 · A1633500013 · A1633500113 · BJ28575 · BJ06126 · BJ07040 · KBJ4453 · BJ14115 · BJ28575PR · K500055 · MS101157 · MS10503 · JBJ765
This part cross-references / interchanges with the following part numbers:
Is this the right 1998-2003 Mercedes-Benz ML320 ball joint?
Yes, TC2133 is a direct-fit replacement for the 1998-2003 Mercedes-Benz ML320. Check the Buyer's Guide tab to confirm engine-level fitment for your exact vehicle.
Will this work as a Mercedes ML350 ball joint on a 2003-2005 or 2010 Mercedes-Benz ML350?
Yes. It is listed for the 2003-2005 and 2010 Mercedes-Benz ML350. Confirm the specific year and engine for your vehicle in the Buyer's Guide tab before ordering.
What position is this ball joint?
It is a rear lower ball joint for the listed Mercedes-Benz applications.
What are signs this ball joint needs replacing?
Clunking from the rear suspension, steering or handling looseness, and uneven tire wear can indicate a worn ball joint. Have the cause diagnosed before replacing.
What material is this Delphi suspension ball joint made of?
It is built with high-quality forgings and machined to micron tolerances, and it uses a chloroprene rubber boot with anti-corrosion protection applied to the part.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
