Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Keep the front wheel properly located and steady with the Dorman control arm 520-541, a front left upper control arm with ball joint that installs as a direct replacement for the original on the 1996-1997 Honda Passport, 1996-1997 Isuzu Rodeo and 1992-1994 Isuzu Trooper. The arm links the chassis to the steering knuckle through its ball joint. This lets the wheel move up and down with the suspension while it holds its position.
This Dorman suspension control arm and ball joint assembly is designed to take the place of the original assembly on the listed applications. It arrives with its key components already in place:
Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and worn bushings or a torn ball joint boot. Diagnose the cause before replacing any parts. Replacing both sides together is recommended, and a wheel alignment should follow installation. See the Buyer's Guide tab for engine-specific fitment.
Interchange: 102-6570
1026570 · CA8051 · 3CB60103 · 8943744192 · 8943744193 · 8943744194 · 8943744195 · RK620638 · FA4891 · GK80107 · GS80107 · CMS80107 · 2605897
This part cross-references / interchanges with the following part numbers:
Which vehicles does this upper control arm fit?
It is a direct replacement for the 1996-1997 Honda Passport, 1996-1997 Isuzu Rodeo and 1992-1994 Isuzu Trooper. Check the Buyer's Guide tab to confirm your exact vehicle.
Which position does this Dorman suspension control arm install in?
It is cataloged for the front left upper position. Replacing both sides together is recommended.
What comes pre-installed on this arm?
The ball joint and bushings come already installed in the arm, which saves time and labor during the repair.
What are signs of a worn upper control arm or ball joint?
Clunking over bumps, loose or wandering steering, uneven tire wear or a torn ball joint boot may mean it needs replacing. Inspect the suspension to confirm the cause first.
Is a wheel alignment needed after installation?
Yes, a wheel alignment is recommended after replacing a control arm. Consult the vehicle service information for the correct fasteners and torque specifications.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.