Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Take care of a worn front suspension corner with this Dorman control arm, part number 524-124, a front right lower unit built as a direct replacement for the original equipment on the 1993-1998 Nissan Quest and 1993-1998 Mercury Villager. The lower arm connects the steering knuckle to the chassis, holding the wheel in position while letting it move through its suspension travel.
Dorman lists this part as a suspension control arm and ball joint assembly. It comes with the ball joint and bushings already installed, so there are no separate components to fit to the arm.
Signs a lower control arm may need replacing include clunking from the front suspension over bumps, loose or wandering steering, and uneven tire wear. If a worn arm, bushing or ball joint at the front right lower position is the cause, this assembly replaces all three at once. It is sold individually, and replacing both sides together is recommended. Consult the vehicle service information for the correct fasteners, torque values and whether the originals may be reused. Engine details are listed on the Buyer's Guide tab.
Interchange: TC6664 · CA14708 · F3XY3078A · CK620341 · RK620341 · GS20132 · CMS20132 · 401600B000 · 545000B000 · F3XY3050A · JTC2391
This part cross-references / interchanges with the following part numbers:
Which vans does this lower control arm fit?
It is a direct-fit replacement for the front right lower position on the 1993-1998 Nissan Quest and 1993-1998 Mercury Villager. Engine details are on the Buyer's Guide tab.
What comes with this assembly?
Each assembly arrives with the ball joint and bushings pre-installed, so you do not need to press in a separate ball joint or bushings. It is sold individually for the front right lower position.
What does a Dorman suspension control arm do?
It links the steering knuckle to the vehicle's chassis. It holds the wheel in position while allowing it to move up and down through its suspension travel.
What are signs the front lower control arm may be worn?
Clunking over bumps, loose or wandering steering, and uneven tire wear can come from a worn arm, bushing or ball joint. Have the suspension inspected to confirm the cause before replacing parts.
Is the Dorman lower control arm protected against rust?
Yes. Dorman adds coatings to help the part resist rust and corrosion.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.