Help keep your Volvo's front end steady and predictable with the Dorman control arm P/N 520-793, a front left lower assembly built as a direct replacement for the original equipment on the 1993-1997 Volvo 850 and the 1998-2000 Volvo S70 and V70.
The lower arm connects the front wheel assembly to the chassis. Its ball joint gives the pivot point for steering and suspension travel. Dorman puts this assembly through an industry-leading evaluation process designed to deliver a smooth ride, directional stability and predictable dynamics.
- Direct replacement: takes the place of the original assembly on the listed applications.
- Complete repair: the ball joint and bushings come pre-installed, saving time and labor on the job.
- Quality engineering: underwent industry-leading testing aimed at a smooth, stable and safe ride.
- Corrosion protection: additional coatings help resist rust and corrosion.
Signs your car may need a new Dorman suspension control arm include clunking over bumps, wandering steering, uneven tire wear or cracked bushings. If a worn arm, ball joint or bushing is the cause, this assembly replaces them in one piece. Replacing the left and right sides together is recommended. Consult the vehicle service information for the correct fasteners and whether the originals may be reused. See the "Vehicles it fits" section for engine details.
Interchange: 102-4691 · 623.39045
1024691 · 62339045 · TC876 · CA10243 · 4CB10121 · RK620193 · FA4346 · GS20486 · CMS20486 · 2605232 · 2605234 · SK520793 · JTC917 · 271901 · 2719011 · 8628495 · 9492530 · 9492914
This part cross-references / interchanges with the following part numbers:
102-4691, 623.39045, TC876, CA10243, 4CB10121, RK620193, FA4346, GS20486, CMS20486, 2605232, 2605234, SK520793, JTC917, 271901, 2719011, 8628495, 9492530, 9492914
Frequently Asked Questions
Which Volvo models does this Dorman lower control arm fit?
It is listed as the front left lower arm for the 1993-1997 Volvo 850 and the 1998-2000 Volvo S70 and V70. See the "Vehicles it fits" section for engine details.
What comes with the Dorman suspension control arm and ball joint assembly?
Each assembly arrives with the ball joint and bushings pre-installed, which saves time and labor compared with sourcing and fitting those parts separately.
What signs suggest a worn control arm?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and cracked or worn bushings. Have the suspension inspected to confirm the cause before replacing parts.
Is the arm protected against rust?
Yes. Dorman applies additional coatings to this assembly to help it resist rust and corrosion.
Should I replace both sides at the same time?
This part covers the front left lower position. Replacing the left and right arms together is recommended for balanced handling, and an alignment check after installation is a good idea.
