Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501045
$189.99
(You save)
Help keep your rear suspension tracking true with the Mevotech Supreme control arm, part number CMS501045. This rear left lower unit installs as a direct-fit replacement for the 2004-2009 Cadillac XLR and 2005-2013 Chevrolet Corvette (see the Buyer's Guide tab to confirm your engine and configuration). As a Mevotech Supreme lower control arm, it positions the rear wheel and, through its integrated ball joint, allows suspension travel while helping keep alignment angles stable.
Superior toughness: patented sintered bearings for longer-lasting performance.
Longer service life: additional surface treatment on the ball joint that helps prevent rust build-up.
Simple to service: a 90-degree SAE grease fitting is included.
Faster fit: a ball joint with a thicker, stronger flange to help prevent deformation during installation, plus a part-specific hex nut.
Forged aluminum construction engineered to OE-level specifications.
This Mevotech Supreme suspension control arm and ball joint assembly is sold individually; replacing the left and right sides together is recommended. If a worn control arm or a failing ball joint is behind clunking over bumps, uneven rear tire wear, or loose handling, this replaces them; diagnose the cause before ordering.
What vehicles does the Mevotech Supreme control arm CMS501045 fit?
It's a direct-fit replacement for the 2004-2009 Cadillac XLR and 2005-2013 Chevrolet Corvette. Check the Buyer's Guide tab to confirm your engine and configuration.
Is the ball joint built into this control arm?
Yes—the ball joint is integrated into the arm, so both are replaced together. This is the rear left lower position.
Can the ball joint be greased?
It includes a 90-degree SAE grease fitting, so the ball joint is serviceable. Add grease following the vehicle's service procedure.
What are the signs I need a new control arm?
Clunking or knocking over bumps, uneven rear tire wear, and loose or imprecise handling can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Does the ball joint resist rust?
The ball joint has additional surface treatment that helps prevent rust build-up, and the arm uses forged aluminum construction.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501045
Service the front suspension of your 2012-2017 Fiat 500 with the Mevotech Supreme control arm and ball joint assembly, MPN CMS101183. This is the front left lower unit, engineered in-house with...
Get tight, controlled handling back with the Mevotech Supreme control arm and ball joint assembly (CMS86139) — a front right lower unit that installs as a direct-fit replacement for the 2006-2019...
Help keep your front suspension tight and your steering response sharp with the Mevotech Supreme control arm, part number CMS901259. This front right lower control arm and ball joint assembly...
Help keep your front-end geometry tight and steering precise with the Mevotech Supreme control arm CMS101632, a direct-fit front left upper control arm with an integrated ball joint for the 2019-2024...
Help keep the front wheel properly located with the Mevotech Supreme control arm (CMS501282), a front right lower forward control arm with an integrated ball joint that drops in as a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
