Delphi TC6337 front left upper control arm with ball joint for the 2006-2010 Infiniti M35 and other vehicles connects the wheel to the car's body and lets it move with the suspension. Sold as a control arm and ball joint assembly, it replaces the arm and its joint in one piece.
- 100% crack detection and ultrasonic flaw detection on each control arm to check the material
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot-welded arm for consistent performance and quality
- Anti-corrosion protection applied to each part
- Tested below -40 degrees C and above 120 degrees C, and exposed to 720 hours of salt spray
Quick facts
- Part: Delphi TC6337 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2006-2010 Infiniti M35 and other vehicles
- Position: Front left upper
- Condition: New
A clunk over bumps, loose steering or uneven tire wear can mean this arm or its ball joint is worn, though a worn sway bar link or tie rod end can produce clunks and steering play of its own, so sort out which part is behind the noise before you replace this one. Upper arms are best replaced as a pair on the same axle, and this listing is one arm for the front left; the right side is a separate part.
Fits
This is a direct-fit replacement for the 2006-2010 Infiniti M35 and the 2006-2010 Infiniti M45, and each takes one for the front left.
Specifications
Fit and size
- Position: front left upper
- Quantity per vehicle: 1 (front left)
Build and materials
- Type: control arm with ball joint
- Construction: robot-welded arm, ball studs machined to micron tolerances
- Finish: anti-corrosion protection
- Condition: new
Interchange: 102-7688 · 54525-EG000 · 522-553
CB61067 · CB61067PR · RK622199 · CMS301121
This part cross-references / interchanges with the following part numbers:
102-7688, 54525-EG000, 522-553, CB61067, CB61067PR, RK622199, CMS301121
Frequently Asked Questions
Does the Delphi TC6337 control arm fit the 2006-2010 Infiniti M45?
Yes. Delphi TC6337 is a front left upper control arm with ball joint for the 2006-2010 Infiniti M45, and the 2006-2010 Infiniti M35 takes it too.
How are the ball studs made on this Delphi control arm?
The ball studs are machined to micron tolerances for durability and smooth joint operation. Each arm also goes through 100% crack detection and ultrasonic flaw detection.
What protects this Delphi control arm against rust?
Anti-corrosion protection is applied to each part. The arm is also robot-welded for consistent performance and quality.
What can a worn upper control arm ball joint feel like while driving?
A clunk over bumps, loose steering feel or uneven tire wear can be signs of wear. A shop can test the ball joint for play safely.
Is 54525-EG000 a cross-reference for the Delphi TC6337 control arm?
Yes. 54525-EG000 is one of the numbers this Delphi TC6337 control arm replaces, along with 102-7688 and 522-553.
