Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1667
$51.99
(You save)
Steady your steering and locate the wheel with the Delphi control arm and ball joint assembly, MPN TC1667 — a front right upper unit that drops in as a direct-fit replacement for the 1989-1997 Ford Thunderbird and 1989-1997 Mercury Cougar. This control arm and ball joint assembly positions the suspension while the integrated ball joint allows the controlled movement your steering and ride depend on.
Delphi applies its OE engineering to its aftermarket steering portfolio, and this part is built to that standard:
Extreme-tested for OE performance: withstands temperatures below -40°C and over 120°C and is exposed to 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Verified integrity: undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Consistent build: robot-welded for repeatable quality, with anti-corrosion protection applied for corrosion prevention and enhanced aesthetics.
Signs this assembly may need replacing include clunking over bumps, wandering steering, and uneven tire wear. Confirm fitment for your Ford Thunderbird control arm or Mercury Cougar control arm application before ordering.
What vehicles does the Delphi TC1667 control arm fit?
It is a direct-fit replacement for the 1989-1997 Ford Thunderbird and 1989-1997 Mercury Cougar. See the Buyer's Guide tab to confirm your exact application.
What position is this control arm and ball joint assembly?
This unit is the front right upper control arm with an integrated ball joint. Verify the position matches your vehicle before ordering.
Is the ball joint included with the control arm?
Yes. The ball joint is integrated into this assembly, so you replace the arm and joint together as one unit.
What are the signs this part may need replacing?
Common signs include clunking over bumps, wandering or loose steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
What corrosion protection does the Delphi control arm have?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics, and Delphi exposes its parts to 720 hours of salt spray during testing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1667
Restore precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position on the...
Tighten up steering response and quiet a worn front corner with the Delphi control arm and ball joint assembly, MPN TC2135. This is a front left upper control arm with the ball joint pre-installed,...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Tighten up your BMW's front end with the Delphi control arm and ball joint assembly, MPN TC2329. It installs as a direct-fit replacement in the front right upper position on the 2007-2014 BMW X5 and...
Replace a worn Nissan Rogue control arm with the Delphi Suspension Control Arm and Ball Joint Assembly TC2467, a front left lower control arm with an integrated ball joint that helps locate the wheel...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
