Help your front suspension deliver a smooth, stable ride with the Dorman control arm 521-715 from Dorman - OE Solutions, a front left lower arm that links the wheel assembly to the vehicle's chassis. It is a direct replacement for the original equipment on the 2007-2011 Honda CR-V. See the "Vehicles it fits" section for engine-level details.
If worn bushings or a loose ball joint are behind clunking, wandering steering or uneven tire wear, this 2007-2011 Honda CR-V control arm replaces the whole arm in one piece. Dorman put it through an industry-leading evaluation process aimed at a smooth ride, directional stability and predictable dynamics.
- Trustworthy replacement: directly replaces the original assembly on the listed applications.
- Complete repair: this Dorman suspension control arm and ball joint assembly comes with the ball joint and bushings pre-installed, which saves installation time and labor.
- Quality engineering: tested through Dorman's industry-leading process, with a smooth, stable and safe ride as the goal.
- Durably designed: additional coatings provide rust and corrosion resistance.
This Dorman lower control arm is for the front left side only. Replacing the right side at the same time is recommended for even handling.
Interchange: 102-6006 · 810-257596B · 623.40013
1026006 · 810257596B · 62340013 · TC2871 · CA14355 · 51360SWAA01 · 51360SWAA20 · 51360SWAE01 · 9CB60086 · RK620500 · GS60109 · CMS60109 · 2605942 · SK521715 · 1509017 · X17CJ1635 · JTC2443
This part cross-references / interchanges with the following part numbers:
102-6006, 810-257596B, 623.40013, TC2871, CA14355, 51360SWAA01, 51360SWAA20, 51360SWAE01, 9CB60086, RK620500, GS60109, CMS60109, 2605942, SK521715, 1509017, X17CJ1635, JTC2443
Frequently Asked Questions
Which vehicles does this part fit?
It is listed for the 2007-2011 Honda CR-V in the front left lower position. See the "Vehicles it fits" section for engine-level details.
What does a lower control arm do?
It connects the wheel assembly to the vehicle's chassis and pivots on its bushings so the wheel can move with the suspension. The ball joint gives the knuckle a pivot point for steering.
What comes with part 521-715?
The arm comes with the ball joint and bushings pre-installed, so they don't have to be pressed in separately. Consult the vehicle service information for the correct fasteners and whether the originals may be reused.
What are signs the control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and worn bushings or a loose ball joint. Have the suspension inspected to confirm the cause.
Should I replace both sides at once?
This part is for the front left lower position only. Replacing the right side at the same time is recommended for even handling, and an alignment check after installation is a good idea.
