Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5208
$123.99
(You save)
Keep the front suspension located and the steering tight with the Delphi control arm TC5208, a front right lower control arm with an integrated ball joint that installs as a direct-fit replacement for the 2011-2014 Hyundai Sonata. The arm positions the wheel and lets the suspension travel, while the ball joint lets the steering knuckle pivot and move through its range. Delphi brings its OE steering and suspension expertise to the aftermarket, so this part is built and tested to match the original.
Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE-level compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection confirm the material matches OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation, with robot welding for consistent quality.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Signs the original may need replacing include clunking over bumps or when turning, loose or wandering steering, and uneven front tire wear. If a worn control arm or ball joint is the cause, this assembly replaces it. An alignment is recommended after installation.
Will this Delphi control arm fit my 2011 Hyundai Sonata?
Yes. The TC5208 is a direct-fit front right lower control arm with ball joint for the 2011-2014 Hyundai Sonata. See the Buyer's Guide tab to confirm your exact vehicle.
What is a control arm and ball joint assembly?
It is a suspension arm with an integrated ball joint that locates the wheel, allows the suspension to travel, and lets the steering knuckle pivot as you steer and hit bumps.
What position does the TC5208 cover?
It is the front right (passenger side) lower control arm. The left side is a separate part, so order the correct side for your vehicle.
How is this Delphi part tested?
Delphi validates it below -40°C, above 120°C, and through 720 hours of salt spray, plus 100% crack and ultrasonic flaw detection to confirm the material matches OE specifications.
Should I replace both sides at once?
Not required, but replacing worn suspension parts in matched pairs can promote balanced handling. An alignment is recommended after installation.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5208
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
Locate and support your front wheel with the Delphi control arm TC6248, a FRONT RIGHT UPPER control arm and ball joint assembly built as a direct-fit replacement for the 2005-2006 Ford Expedition and...
Restore precise wheel location and quiet handling on your Honda Accord control arm job with the Delphi Suspension Control Arm and Ball Joint Assembly (TC7868). This rear upper control arm and ball...
Keep your Audi's front suspension located and steering-true with the Delphi control arm and ball joint assembly (TC801). This is the front left upper rearward arm, a direct-fit replacement that pairs...
Restore precise steering and a solid front end with the Delphi control arm TC802, a direct-fit replacement control arm and ball joint assembly for the front right upper rearward position on a wide...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
