Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3033
$289.99
(You save)
Delphi TC3033 control arm with ball joint for the 2012-2019 Land Rover Range Rover Evoque locates the front right wheel and lets it move with the road. This Delphi control arm is supplied as a control arm and ball joint assembly.
Withstands temperatures below -40 degrees C and over 120 degrees C, and is exposed to 720 hours of salt spray
100% crack detection and ultrasonic flaw detection, so materials match OE specifications
Ball studs machined to micron tolerances for durability and smooth joint operation
Robot welding for consistent performance and quality
Anti-corrosion protection applied to each part
A clunk over bumps, uneven tire wear or loose steering can mean a worn arm or ball joint. Before replacing it, park the car with the engine off and look the arm over for cracks, bends or rust. A bushing or link can make similar noises, so have a shop confirm the cause if nothing shows. This listing is one piece, and the arms on both sides are normally replaced together.
This arm is a direct-fit replacement on the 2012-2019 Land Rover Range Rover Evoque, which takes one in the front right lower position.
Is the Delphi TC3033 control arm for the front right or left side of the 2012-2019 Land Rover Range Rover Evoque?
Delphi TC3033 is the front right lower control arm with ball joint for the 2012-2019 Land Rover Range Rover Evoque. It is sold as one piece per listing.
Does this control arm come with the ball joint already attached?
Yes. Delphi TC3033 is a control arm with ball joint, so the ball joint is part of the assembly and does not need to be bought separately.
How does Delphi test these control arms for heat, cold and salt spray?
The test range runs from below -40 degrees C to over 120 degrees C, plus 720 hours of salt spray. Delphi also puts its control arms through 100% crack detection and ultrasonic flaw detection.
What can a worn front lower control arm feel like on the road?
A worn arm or ball joint can show up as a knock over bumps, the car pulling to one side, or uneven tire wear. A shop can check the ball joint for play.
Is the Delphi TC3033 a replacement for number LR0 24472?
Yes. LR0 24472 is one of the numbers Delphi TC3033 replaces, along with LR0 45803, LR0 78656 and the other cross-reference numbers listed at the bottom of the page.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3033
Help bring precise steering geometry and a solid front end back to your Audi or Volkswagen with the Delphi control arm and integrated ball joint, MPN TC1343. This front lower forward assembly locates...
Steer with confidence and help restore proper suspension geometry with the Delphi control arm and ball joint assembly, MPN TC2230. This is the front right lower rearward unit, and it drops in as a...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Help keep steering precise and wheel control steady with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Replace a worn joint and help keep the front wheel located precisely with the Delphi control arm, part number TC2597. This front right lower control arm and ball joint assembly is a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
