Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301265
$114.99
(You save)
Help tighten up handling at a worn front corner with the Mevotech Supreme control arm CMS301265, a front left lower control arm with a pre-installed ball joint. It drops in as a direct-fit replacement for the 2018-2024 Nissan Kicks and 2020-2025 Nissan Versa (see the Buyer's Guide tab for the full engine list). The arm locates the wheel and controls its travel, while the integrated ball joint allows the steering and suspension to move; worn originals often show up as clunking over bumps, loose or wandering steering, and uneven tire wear.
Resists corrosion: a protective surface treatment helps prevent rust build-up and adds longevity.
Precise engineering: innovated inside and out for high durability and easy installation.
Premium materials: used on all components for longer part life.
Rigorous testing: extensive in-house and third-party durability testing.
Built for high-usage passenger, fleet and commercial duty, this Mevotech Supreme suspension control arm is engineered as an application-specific upgrade. If a failed control arm or ball joint is behind your symptoms, this 2020-2025 Nissan Versa lower control arm replaces the front left lower unit.
What is the Mevotech Supreme control arm and ball joint assembly CMS301265?
It is a front left lower control arm with a pre-installed ball joint that locates the wheel and lets the steering and suspension move, sold as a direct-fit replacement unit.
Which vehicles does the CMS301265 fit?
It is a direct-fit replacement for the 2018-2024 Nissan Kicks and 2020-2025 Nissan Versa. Check the Buyer's Guide tab to confirm the engine for your vehicle.
What position on the vehicle is this control arm for?
This assembly is the front left (driver-side) lower control arm. Order the opposite side separately; replacing both sides together is recommended.
What are signs this part may need replacing?
Clunking over bumps, loose or wandering steering, and uneven tire wear can be signs of a worn control arm or ball joint. Diagnose the cause before replacing.
Is the ball joint included with this control arm?
Yes. The ball joint comes pre-installed in the control arm, so the assembly installs as one unit for the front left lower position.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301265
Help maintain steering geometry and wheel control with the Mevotech Supreme control arm and ball joint assembly (CMS301032), a direct-fit front left (driver's side) lower unit for the listed...
Pivot the front wheel through steering and suspension travel with the Mevotech Supreme control arm CMS101371, a front right lower control arm and ball joint assembly. It installs as a direct-fit...
Help bring back tight, quiet front-end travel with the Mevotech Supreme control arm, MPN CMS501128 — a direct-fit replacement for the 2010-2015 Chevrolet Camaro. This front right (passenger-side)...
Keep your rear wheel located and your alignment on spec with the Mevotech Supreme control arm, part number CMS40156. This rear left upper control arm and ball joint assembly drops in as a direct-fit...
Support steady front-end control with the Mevotech Supreme control arm CMS90185, a direct-fit replacement for the front left lower forward position on the 2011-2013 Hyundai Equus and 2009-2014...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
