Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS601268
$187.99
(You save)
Replace a worn Honda Odyssey control arm with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS601268) — a front left lower unit that locates the wheel, anchors the suspension, and pivots on its integrated ball joint. It installs as a direct-fit replacement for the 2018-2025 Honda Odyssey.
This Mevotech Supreme control arm is engineered in-house with application-specific upgrades:
Forged aluminium arm: Built with a filled-in hole/recess for added strength and durability.
Patented BiMetallic technology: A greaseable sintered bearing solution designed to address high heat and high load in tight spaces for extended service life.
Upgraded bushings: A solid cross-section with added knurling for increased stiffness and durability.
Serviceable ball joint: Features a larger-sphere ball stud system, a thicker, stronger flange to resist deformation during installation, additional surface treatment that helps prevent rust build-up, and a 180-degree SAE grease fitting.
Installation is straightforward: secure the ball joint to the vehicle with the part-specific castle nut and easy snap cotter pin provided. This Mevotech Supreme suspension control arm is a high-usage design suited to passenger vehicles, SUVs and fleets.
What vehicles does this Mevotech Supreme lower control arm fit?
It is a front left lower control arm and ball joint assembly for the 2018-2025 Honda Odyssey. See the Buyer's Guide tab to confirm fitment for your vehicle.
Is the ball joint included with this Odyssey control arm?
Yes. The ball joint is integrated into the assembly and is serviceable, featuring a larger-sphere ball stud and a 180-degree SAE grease fitting for lubrication.
What hardware is included for installation?
A part-specific castle nut and an easy snap cotter pin are provided to secure the ball joint to the vehicle. Consult the service information for the correct torque values.
What are signs this control arm may need replacing?
Clunking or knocking over bumps, loose or wandering steering, and uneven tire wear can be signs of a worn control arm bushing or ball joint. Diagnose the cause before replacing.
What material is this Mevotech Supreme control arm made from?
It uses a forged aluminium arm with a filled-in hole/recess for added strength, plus BiMetallic technology with a greaseable sintered bearing for extended service life.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS601268
Firm up steering response and restore tight front-end geometry with the Mevotech Supreme Control Arm with Ball Joint CMS251267 — a front left upper control arm and ball joint assembly that installs...
Reach for the Mevotech Supreme control arm CMK80342 when the front right upper suspension on your 2003-2006 Kia Sorento has gone loose or noisy. This control arm and ball joint assembly locates the...
Steady your steering and keep front-suspension geometry in check with the Mevotech Supreme control arm, MPN CMS101428. This front right lower control arm and ball joint assembly drops in as a...
Bring precise steering and a stable ride back to your front corner with the Mevotech Supreme control arm CMS501119, a front lower left suspension control arm and ball joint assembly. It drops in as a...
Locate the front wheel and control suspension travel with the Mevotech Supreme control arm and ball joint assembly (CMS251043), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
