Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Dorman 524-155 front lower control arm with ball joint for the 2006-2010 Dodge Charger and other vehicles links the wheel to the chassis and lets the suspension move. This Dorman suspension control arm and ball joint assembly replaces the arm, ball joint and bushings as one unit.
A clunk over bumps, vague steering or uneven tire wear can mean the arm, ball joint or bushings are worn, though a worn sway bar link or strut mount can produce similar signs, so pin down the source before buying.
This arm is a direct replacement for the original on specific applications. It is listed for a wide range of Dodge and Chrysler models, including the 2005-2010 Chrysler 300 and the 2008-2010 Dodge Challenger.
Fit and size
Build and materials
One control arm with ball joint, a grease fitting and mounting hardware. This listing is one arm; vehicles that use it take two, one for each side, and both sides are normally replaced together.
Interchange: 4782561AB · 4782561AC · 4782561AD · 4782561AE · 4782561AF · 68002123AA · 68002123AB · 68002123AC · 68159271AA · TC5546 · CA5276 · RK640664 · GS25119 · CMS25119 · 2CB25057 · X13CA1454
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does this Dodge Charger control arm fit a 2006-2010 Charger with any engine?
Yes. Dorman 524-155 is the front lower rearward arm for the 2006-2010 Dodge Charger, whatever the engine. If your car is another model, look it up in the "Vehicles it fits" section on this page.
Is this the right control arm for the 2005-2010 Chrysler 300?
Yes. This front lower control arm is listed for the 2005-2010 Chrysler 300, in the front lower rearward position, and the engine does not change the fit.
Does this Dorman control arm come with the ball joint and bushings installed?
Yes. The ball joint and bushings arrive already installed, and a grease fitting and mounting hardware are included with the arm.
What size is the ball joint thread on Dorman 524-155?
Dorman 524-155 has a threaded ball joint stud with a 14 mm thread diameter and a 61 mm stud length. The ball joint mounts bolt-in.
Does Dorman 524-155 replace the 4782561AB control arm?
Yes. 4782561AB is one of the numbers this Dorman arm replaces, along with 68159271AA and CA5276.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.