Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS30155

Restore precise wheel location and tight steering on your Nissan Altima with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS30155). This front right lower assembly is a direct-fit replacement for the 2007-2013 Nissan Altima — see the Buyer's Guide tab for the engine-level breakdown. It locates the wheel, allows suspension travel, and its integrated ball joint carries the steering knuckle; worn examples can show clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear.

• Forged aluminum arm: A forged aluminum control arm with a thicker cross section adds strength and durability for high-usage commercial, fleet, and passenger vehicles.
• Patented BiMetallic technology: Greaseable sintered bearings are engineered to address high heat and high load in tight spaces for extended service life on unitized aluminum arms.
• Longer ball joint life: Additional surface treatment on the ball joint helps prevent rust build-up, and a 90-degree SAE grease fitting is included to make servicing simple.
• Fasteners included: Ships with an application-specific pinch bolt and locking nut, plus pre-applied nylok thread adhesive to keep fasteners secure and vibration resistant.

Built with Mevotech Supreme's application-specific, Labor Saver upgrades for faster, easier installation.