Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301266
$114.99
(You save)
Steady your steering and quiet a clunking front corner with the Mevotech Supreme control arm with ball joint (CMS301266), a direct-fit replacement for the FRONT RIGHT LOWER position on the 2018-2024 Nissan Kicks and 2020-2025 Nissan Versa. It combines the lower control arm, its pressed-in bushings, and an integrated ball joint into one bolt-on unit that locates the wheel and lets the suspension travel and steer.
Resists corrosion: a protective surface treatment helps guard against rust build-up.
Precise engineering: engineered in-house with application-specific upgrades for durability and easier installation.
Premium materials: used across the components for longer part life.
Rigorous testing: extensive in-house and third-party durability testing verifies strength and performance.
As a complete Mevotech Supreme lower control arm assembly, it spares you pressing a separate ball joint or bushings into a bare arm. Signs the original may need replacing include clunking or knocking over bumps, uneven tire wear, and loose or wandering steering — if a worn control arm or ball joint is the cause, this replaces it. Shopping a Nissan Versa control arm or Nissan Versa lower control arm for the right-front corner? This Mevotech Supreme suspension control arm is a direct-fit replacement for the listed applications.
What vehicles does the Mevotech Supreme control arm CMS301266 fit?
It's a direct-fit front right lower assembly for the 2018-2024 Nissan Kicks and 2020-2025 Nissan Versa. See the Buyer's Guide tab to confirm your exact engine and trim.
What is a control arm and ball joint assembly?
It's a single unit combining the lower control arm, its bushings, and an integrated ball joint. It locates the wheel and lets the suspension move and steer, so you replace everything at once.
What are signs my control arm or ball joint needs replacing?
Clunking or knocking over bumps, uneven tire wear, and loose or wandering steering can point to a worn control arm or ball joint. Diagnose the cause before replacing.
Which corner of the vehicle does this fit?
This assembly is cataloged for the front right (passenger-side) lower position on the listed applications.
Do I need to replace both sides at once?
This listing is one assembly for the front right corner. Replacing the matching left-side unit at the same time is good practice for balanced handling, though not strictly required.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301266
Get tight, controlled handling back with the Mevotech Supreme control arm and ball joint assembly (CMS86139) — a front right lower unit that installs as a direct-fit replacement for the 2006-2019...
Keep your front suspension tight and your steering response sharp with the Mevotech Supreme control arm, part number CMS901259. This front right lower control arm and ball joint assembly installs as...
Help tighten front-end steering feel and quiet a loose ride with the Mevotech Supreme control arm and ball joint assembly, MPN CMS90151. This front right lower unit combines the control arm with its...
Get precise wheel location back with the Mevotech Supreme control arm, part number CMS90110 — a direct-fit replacement for the 2001-2003 Hyundai Santa Fe. This rear left upper control arm positions...
Keep the front wheel precisely located and the steering responsive with the Mevotech Supreme control arm, part number CMS70104. This front left lower unit installs as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
