Dorman - OE Solutions Suspension Control Arm Bushing P/N:523-655
Help keep your front left wheel properly located as the suspension travels with the Dorman control arm 520-655 from the OE Solutions line. It is a front left lower arm built as a direct replacement for the 2004-2006 Acura TL. See the Buyer's Guide tab for engine details.
If you are shopping for a 2004-2006 Acura TL control arm, this Dorman lower control arm connects the wheel assembly to the vehicle's chassis and pivots as the suspension moves up and down. That helps hold the wheel in position for steering and ride. Dorman describes it as precision-engineered and rigorously tested to serve as a dependable stand-in for the original equipment on specific vehicles.
Signs a suspension control arm may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and vibration through the steering wheel. Worn ball joints, tie rods and other parts can cause the same symptoms, so diagnose the cause before replacing. If a worn control arm is behind the problem, this arm replaces it. A wheel alignment is recommended after installation.
Interchange: 102-7931
1027931 · TC5571 · CA14711 · 51360SEPA00 · 5CB60208 · RK641543 · GS601021 · CMS601021 · 2607592 · SK641543 · X02CA6872 · JTC2726
This part cross-references / interchanges with the following part numbers:
Is this the right control arm for a 2004-2006 Acura TL?
Dorman 520-655 is a direct replacement front left lower arm for 2004-2006 Acura TL models. Check the Buyer's Guide tab for engine details.
Which position does this control arm fit?
It is the front left lower control arm. This listing covers the left side. Replacing the right side at the same time is often recommended for even, balanced handling.
What does a control arm do?
It connects the wheel assembly to the vehicle's chassis and pivots as the suspension moves. This helps keep the wheel located for steering and ride.
What are signs this control arm may need replacing?
Clunking over bumps, wandering steering, uneven tire wear or steering-wheel vibration may be signs of a worn arm. Other worn parts cause the same symptoms, so diagnose first.
Is an alignment needed after installation?
Yes. A wheel alignment is recommended after replacing a control arm. Consult the vehicle service information for torque specs and whether the original fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.