Delphi Suspension Stabilizer Bar Link Kit P/N:TC6035
$41.99
(You save)
Keep your stabilizer bar working with the body roll it's meant to control using the Delphi Suspension Stabilizer Bar Link Kit TC6035. This front sway bar link kit installs as a direct-fit replacement for the 2010 Dodge Ram 2500 and Ram 3500, and the 2011-2013 Ram 2500 and Ram 3500 — see the Buyer's Guide tab for engine-level fitment. The link ties the front stabilizer bar to the suspension, and worn links commonly show up as clunking or rattling over uneven roads and vague, sloppy handling through turns.
Fatigue tested: each sway bar link is fatigue tested to help avoid premature failure.
Ultrasonic molding: built using ultrasonic molding to help prevent future weld breakage.
Micron tolerances: machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Delphi carries its OE engineering into its aftermarket steering portfolio, testing to the extreme: parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, while extensive dimensional and material analysis targets close compatibility between the OE and aftermarket part. Sold as a kit for the front stabilizer bar; replace both sides together as a matched pair for balanced handling.
It's a direct-fit front replacement for the 2010 Dodge Ram 2500 and Ram 3500, plus the 2011-2013 Ram 2500 and Ram 3500. Check the Buyer's Guide tab to confirm your exact application.
What does a sway bar link do?
It connects the front stabilizer bar to the suspension so the bar can resist body roll. When links wear, the bar can't do its job as effectively, allowing more lean and noise.
What are the signs this stabilizer bar link kit may need replacing?
Common signs include clunking or rattling over bumps and uneven roads, and loose or vague handling through turns. Have the cause diagnosed, since other suspension parts can produce similar symptoms.
Should I replace both sway bar links at once?
Replacing both front links together is recommended so handling stays balanced side to side. This kit covers the front stabilizer bar links for the listed applications.
Is the Delphi TC6035 corrosion protected?
Yes. Anti-corrosion protection is applied to each part for corrosion prevention and improved appearance, and Delphi exposes its parts to 720 hours of salt spray during testing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC6035
Quiet a clunking front end and help keep body lean in check with the Delphi Suspension Stabilizer Bar Link Kit TC8477. This front sway bar link connects the stabilizer bar to the suspension on the...
Tie the front stabilizer bar to the suspension and help control body roll through every corner with the Delphi Suspension Stabilizer Bar Link Kit (TC2265). This front sway bar link kit is a...
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Keep the front sway bar working with the driver — and quiet the clunks and rattles that a worn link lets through — with the Delphi Suspension Stabilizer Bar Link Kit TC2912. This front sway bar link...
Keep your rear stabilizer bar tied firmly to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2919. This rear-position sway bar link kit drops in as a direct-fit replacement for...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
