Smooth out a worn front end and bring back factory ride height with the Monroe Quick-Strut Suspension Strut and Coil Spring Assembly 171684. This all-in-one front unit drops in as a direct-fit replacement for the 1998-2004 Cadillac Seville, arriving fully assembled so there's no need for a spring compressor during installation. Monroe builds each Quick-Strut with a vehicle-specific design that is fit-checked and ride-tested to restore ride height and ride performance.
Backed by Monroe's Limited Lifetime Warranty and Feel the Difference Guarantee.
Interchange: 22064767 · 18816329 · LS3485511B · 1331733 · G57051 · 33GM1149 · 819222 · 92140523
This part cross-references / interchanges with the following part numbers:
What vehicle does this Quick-Strut fit?
It is a direct-fit front strut and coil spring assembly for the 1998-2004 Cadillac Seville. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Do I need a spring compressor to install it?
No. The Monroe Quick-Strut 171684 ships fully assembled with the strut, coil spring, and upper mount together, so no spring compressor is required for the strut replacement.
Is this a front or rear assembly?
This is a front suspension strut and coil spring assembly.
What is included in the assembly?
It includes the preassembled upper strut mount, application-specific coil spring, and strut in a single ready-to-install unit.
Should I replace both sides at the same time?
This listing is for one assembly. Replacing struts in pairs across the axle is a common best practice for balanced ride and handling; follow your vehicle's service information.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
