Timken HA590106 wheel bearing and hub assembly for the 2005-2018 Volkswagen Jetta and other vehicles carries the wheel and lets it turn on the axle. OE-developed tests control the design, materials and manufacturing process of the hub bearing assemblies.
- Low runout reduces noise and vibration and helps braking performance
- Seals with a reinforced outer case, ribbed rubber inner diameter and contamination exclusion system
- Precision bearing profiles, uniform internal geometry and enhanced surface finishes for load carrying capacity and bearing life
- ABS sensors are 100% tested to monitor wheel speed for anti-lock braking systems
Quick facts
- Part: Timken HA590106 wheel bearing and hub assembly
- Fits: the 2005-2018 Volkswagen Jetta and other vehicles
- Position: Front, rear
- Condition: New
A worn wheel bearing and hub assembly can show up as humming or growling that changes with speed, vibration, or an ABS warning light. Tires, brakes and other chassis parts can make noise too, so look the tires and brakes over with the engine off, and have a shop test the bearing before you replace it.
Fits
The 2005-2018 Volkswagen Jetta, the 2012-2022 Volkswagen Passat and the 2009-2017 Volkswagen Tiguan are direct fits for this hub assembly, and so are many other vehicles. A 2005-2018 Volkswagen Jetta takes two. This listing is one hub assembly, and the other side of the same axle is normally done at the same time. If your car is not named here, find it in the "Vehicles it fits" section.
Specifications
Fit and size
- Position: Front, rear
- Quantity per vehicle: 2
- Bolt circle diameter: 113.83 mm (4.481 in)
- Flange diameter: 136.83 mm (5.387 in)
- Flange offset: 48.00 mm (1.890 in)
- Brake pilot diameter: 65.00 mm (2.560 in)
- Hub pilot diameter: 85.00 mm (3.346 in)
- Wheel pilot diameter: 57.00 mm (2.244 in)
- Flange bolt holes: 4
- Wheel studs: 5
- Splines: 36
Build and materials
- Type: hub unit assembly
- Drive type: driven
- Condition: new
Installation notes
- Supplied preset, pre-greased and pre-sealed.
- Vent holes in the seals prevent damage during installation.
Interchange: 051-6258 · 400.33000E
WE60756 · 513253 · BR930623 · WKH3643
This part cross-references / interchanges with the following part numbers:
WE60756, 051-6258, 400.33000E, 513253, BR930623, WKH3643
Frequently Asked Questions
Does the Timken HA590106 fit a 2005-2018 Volkswagen Jetta?
Yes. Timken HA590106 is a direct fit for the 2005-2018 Volkswagen Jetta, which takes two. If your car is a different one, find it in the "Vehicles it fits" section.
What are the bolt circle and pilot sizes of Timken wheel hubs like the HA590106?
Timken HA590106 has a 113.83 mm (4.481 in) bolt circle, a 65.00 mm brake pilot, an 85.00 mm hub pilot and a 57.00 mm wheel pilot. It has 5 wheel studs and 4 flange bolt holes.
Does this Timken wheel bearing come greased and sealed?
Yes. This hub assembly is supplied preset, pre-greased and pre-sealed, and its seals have vent holes that prevent damage during installation.
How can I tell if Timken hub bearings are wearing out?
A humming or growling noise that changes with speed, vibration, or an ABS warning light can mean a hub bearing is wearing out. A shop can test the bearing.
Are Timken front wheel bearings sold in pairs?
No. This Timken HA590106 listing is one hub assembly, and the catalog gives its position as front and rear. The other side of the same axle is normally done at the same time.
