TrakMotive AD-8191 rear CV axle shaft for the 2017-2022 Audi Q7 sends drive torque to the rear wheel while the suspension moves up and down. This TrakMotive CV axle has a flexing joint at each end, so power keeps flowing through wheel travel.
- Bolt-on inboard joint
- Spline bolt outboard joint with 42 outboard splines
- Neoprene boots on both the inboard and outboard joints
Quick facts
- Part: TrakMotive AD-8191 CV axle shaft
- Fits: 2017-2022 Audi Q7
- Position: Rear
- Condition: New
A clicking noise when turning, vibration under acceleration or grease thrown from a torn boot can point to a worn axle. A worn wheel bearing, an out-of-balance tire or a loose suspension joint can cause similar noise or vibration, so find the cause before buying an axle.
Fits
It fits the 2017-2022 Audi Q7, which takes two. This listing is one shaft, and the other side of the same rear axle is normally replaced at the same time.
Specifications
Fit and size
- Position: Rear
- Quantity per vehicle: 2
- Overall compressed length: 675 mm (26.56 in)
- Overall extended length: 747 mm (29.39 in)
- Inboard joint bolt holes: 6
- Outboard joint bolt holes: 1
- Axle bolt: M16x1.5 thread, 17 mm hex, 85 mm long
Build and materials
- Boot material: neoprene (inboard and outboard joints)
- ABS tone ring: not included
- Axle nut: not included
- Condition: New
- Warranty: TrakMotive limited lifetime warranty
- Country of origin: China
In the box
One CV axle shaft. The axle nut is not included, so plan on a new one rather than reusing the old.
Interchange: NCV20002K · NCV23061 · 4M0501203D
This part cross-references / interchanges with the following part numbers:
NCV20002K, NCV23061, 4M0501203D, AD-8191
Frequently Asked Questions
Does the TrakMotive AD-8191 rear CV axle shaft fit the 2017-2022 Audi Q7?
Yes. TrakMotive AD-8191 is a rear axle shaft for the 2017-2022 Audi Q7, and the Q7 takes two, one for each rear side.
What warranty comes with the TrakMotive CV axle shaft?
TrakMotive backs this CV axle shaft with a limited lifetime warranty.
Does this rear CV axle shaft come with the axle nut?
No. The axle nut is not included, so plan on a new one. The ABS tone ring is not included either.
How long is the TrakMotive AD-8191 axle shaft?
The TrakMotive AD-8191 measures 675 mm (26.56 in) compressed and 747 mm (29.39 in) extended.
Does AD-8191 replace NCV23061?
Yes. NCV23061 is one of the numbers this rear axle shaft replaces; NCV20002K and 4M0501203D are also listed.
