Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8411
$188.99
(You save)
Keep your front-end geometry tight and your steering responsive with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8411. This front right lower control arm locates the wheel, supports suspension travel, and pivots on its bushings while the integrated ball joint ties the knuckle to the suspension. It installs as a direct-fit replacement for the 2018-2023 Hyundai Kona — see the Buyer's Guide tab for engine-level fitment.
Complete assembly: the control arm comes with its ball joint already fitted for a one-piece installation.
Matches OE form, fit and function: designed as a direct replacement for the original equipment application on the listed vehicle.
Durable construction: built with steel, iron, or aluminum construction for strength and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable.
Worn control-arm bushings or a loose ball joint can show up as clunking over irregular surfaces, wandering steering, or uneven tire wear. If the original front right lower arm on your Kona is worn, this Beck/Arnley assembly (MPN 102-8411) replaces it. Diagnose the cause before ordering, and inspect the opposite side while servicing.
Interchange: 2703668230 · 54501J9000 · CMS801223
This part cross-references / interchanges with the following part numbers:
2703668230, 54501J9000, CMS801223
Frequently Asked Questions
What position does this control arm fit?
It is the front right (passenger-side) lower control arm assembly for the listed Hyundai Kona applications.
Does it include the ball joint?
Yes. The control arm comes with the ball joint already fitted, so it installs as a complete one-piece assembly.
Which vehicles does this fit?
It is a direct-fit replacement for the 2018-2023 Hyundai Kona. Check the Buyer's Guide tab for engine-level fitment details.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs this control arm may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to worn bushings or a failing ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8411
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
