Beck/Arnley Suspension Control Arm P/N:102-6596
Shopping for RSX lower control arms? The Beck/Arnley Suspension Control Arm 102-8077 is a front left lower control arm that installs as a direct replacement on the 2005-2006 Acura RSX. The control arm locates the front wheel knuckle, houses the pivot bushings, and controls suspension travel — when worn bushings cause clunking over bumps, wandering steering, or uneven tire wear, replacing the arm addresses that source if it is the cause.
As an application-specific part, the 102-8077 provides the correct front left lower mounting points and pivot geometry for the listed Acura RSX.
Interchange: 51360S6MA10 · 51360S6MA11 · 51360S6MA50 · 51360S6MA51 · 37101038001 · RK642168 · W01331835897
This part cross-references / interchanges with the following part numbers:
Does this Acura Rsx control arm fit my vehicle?
It is a direct replacement for the 2005-2006 Acura RSX. Check the Buyer's Guide tab and confirm the fitment for your specific vehicle before ordering.
What position is this Rsx control arm?
It is the front left (driver-side) lower control arm for the listed Acura RSX applications.
Does it come with a ball joint?
No. This control arm comes without a ball joint, which matches the OE design for this application.
What is the control arm made of?
It uses steel, iron, or aluminum construction for durability and rust/corrosion resistance, depending on the application.
Are hardware and bushings included?
New hardware and bushings are included where applicable for this vehicle. Consult the service information for the correct fasteners and whether any may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.