Oxygen Sensor for 2007-2011 Rolls-Royce Phantom & More - Bosch 17126

Bosch 17126 oxygen sensor for the 2007-2011 Rolls-Royce Phantom V12 6.7L and other vehicles reads the exhaust's air-fuel ratio and reports it to the ECU. The ECU gets far more detail than from a traditional switching sensor, which supports fuel efficiency and lower emissions.

• Wide-band design takes continuous air-fuel ratio readings across the full lambda range
• Reaches operating temperature in under 7 seconds for quick closed-loop control
• Withstands exhaust streams up to 1,880°F
• Metal housing, integrated heater element and TSP coating resist vibration, corrosion and contamination
• Optimized heater control and ceramic construction hold up through rapid load changes and harsh thermal cycles

Quick facts

• Part: Bosch 17126 oxygen sensor
• Fits: 2007-2011 Rolls-Royce Phantom V12 6.7L and other vehicles
• Position: Upstream, upstream left, upstream right
• Material: Metal housing
• Condition: New

A worn wide-band sensor can show up as a check engine light, rough running or poor fuel economy. Those signs alone don't prove the sensor is at fault, since an exhaust leak ahead of it can throw the readings off too.

Fits

This oxygen sensor is listed for a wide range of BMW models and the 2007-2011 Rolls-Royce Phantom V12 6.7L, among them the 2006-2010 BMW 550i V8 4.8L and the 2006-2010 BMW 650i V8 4.8L. If your car isn't named here, look it up on the Buyer's Guide tab.

Specifications

In the box

One oxygen sensor with its wiring harness. This listing is one sensor; the 2007-2011 Rolls-Royce Phantom V12 6.7L takes two and the 2006-2010 BMW 550i V8 4.8L takes one.

Installation notes

• Direct-fit connectors.
• Conductive anti-seize is pre-applied to the threads.