Rear Right Brake Caliper for 2004-2010 Toyota Sienna - CARDONE Reman 19-B2872

Be the first to review this product
$89.99
MPN: 19-B2872
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

CARDONE Reman Disc Brake Caliper P/N:19-B2872
CARDONE Reman Disc Brake Caliper P/N:19-B2872
$89.99

Get dependable clamping force for the listed applications with the A1 CARDONE Remanufactured Unloaded Disc Brake Caliper 19-B2872, a rear right 2004-2010 Toyota Sienna brake caliper that installs as a direct-fit replacement for the listed applications. A brake caliper squeezes the brake pads against the rotor to slow the wheel, and worn or seized units can drag, pull to one side, or leak fluid.

  • Rebuilt and pressure-tested: Each unit is remanufactured with brand-new premium components and 100% pressure-tested for consistent performance.
  • New seals and piston: Fitted with new high-temperature EPDM rubber seals and a durable piston that resists cracking and pitting under load.
  • Hardware included: Arrives with new bleeder screws, plus new banjo bolts, washers, stainless steel clips and mounting pins where applicable; caliper bracket is included where applicable.
  • Protected finish: Treated with a rust inhibitor and kept in the original equipment finish, with a plastic cap plug guarding each brake port thread.

This is an unloaded caliper, so brake pads are not included. As a remanufactured Original Equipment part, it is built to bolt into place on the applications above. Replacing the caliper on both sides of an axle as a matched pair is good practice for balanced braking. See the Buyer's Guide tab for engine-level fitment.

Interchange: 4773028270

This part cross-references / interchanges with the following part numbers:

4773028270

Frequently Asked Questions

Does this A1 CARDONE caliper fit my 2004-2010 Toyota Sienna?

It is a direct-fit replacement for the 2004-2010 Toyota Sienna. Check the Buyer's Guide tab to confirm engine-level fitment for your specific vehicle before ordering.

Are brake pads included with this caliper?

No. This is an unloaded caliper, so brake pads are not included. It does come with a full set of new hardware, and the caliper bracket is included where applicable.

Is this A1 CARDONE brake caliper new or remanufactured?

It is remanufactured with brand-new premium components, then 100% pressure-tested. New EPDM seals and a durable piston are installed, and it's kept in the original equipment finish.

What hardware comes with this caliper?

It ships with new bleeder screws, plus new banjo bolts, washers, stainless steel clips and mounting pins where applicable. A plastic cap plug protects each brake port thread.

Should I replace both calipers at once?

Replacing the caliper on both sides of the axle as a matched pair is good practice for balanced, even braking, though this listing covers the single unit described.