Delphi FE0415 electric fuel pump for the 2007-2012 Hyundai Elantra 4-cylinder 2.0L and other vehicles moves fuel from the tank to the engine. This Delphi electric fuel pump goes inside the tank, and each tank takes a single pump.
- Designed to operate under extreme temperatures with quick engine starts
- Pump design intended to improve performance and durability
- Built to bring back fast pressure performance and system integrity using less energy
- Validated and tested for its application
- Lower amperage draw puts less load on the vehicle's electrical system
Quick facts
- Part: Delphi FE0415 electric fuel pump
- Fits: 2007-2012 Hyundai Elantra 4-cylinder 2.0L and other vehicles
- Position: In-tank
- Condition: New
Hard starting, stalling or a drop in power can come from a worn fuel pump. A clogged fuel strainer, a bad relay or a blown fuse can be behind them too, so track down the cause before buying a pump.
Fits
The 2000-2006 Nissan Sentra and the 1999-2004 Nissan Frontier V6 3.3L are on the list as well, along with many other vehicles. If your car isn't one of these, look it up in the "Vehicles it fits" section.
Specifications
- Position: In-tank
- Quantity per vehicle: 1
- Condition: New
In the box
One electric fuel pump, three caps, two hose clamps, a hose piece, an isolator, a pall nut, a seal, a spacer, two splices, a 2-wire harness with connector and an instruction sheet.
Installation notes
- Check and clean the fuel tank during the job.
- Replace the fuel strainer whenever you repair a fuel pump.
- An instruction sheet comes with the pump.
Frequently Asked Questions
Is this Elantra electric fuel pump right for the 2007-2012 Hyundai Elantra 4-cylinder 2.0L?
Yes. Delphi FE0415 is listed for the 2007-2012 Hyundai Elantra 4-cylinder 2.0L, and it is an in-tank pump.
Does the Delphi FE0415 come with a wiring harness and hose clamps?
Yes. Delphi FE0415 comes with a 2-wire harness with connector, two hose clamps, three caps, a hose piece, an isolator, a pall nut, a seal, a spacer, two splices and an instruction sheet.
Do I need a new fuel strainer when I replace this fuel pump?
A strainer is not in the box. Replace the fuel strainer whenever you repair a fuel pump, and check and clean the fuel tank at the same time.
Is this fuel pump an in-tank or inline design?
In-tank. This pump sits inside the fuel tank, and the tank takes one.
Is the Delphi FE0415 built for extreme temperatures?
Yes. Delphi designs this pump to operate under extreme temperatures with quick engine starts, and its lower amperage puts less load on the vehicle's electrical system.
