Delphi HP10268 fuel pump hanger for the 1992 Buick Park Avenue V6 3.8L and other vehicles holds the float arm and fuel tubes inside the tank. Delphi builds its fuel pumps to its own OE standards, and this hanger is validated and tested for its vehicle application.
- Pump designed to operate under extreme temperatures with quick engine starts
- Metal tubes routed so they never touch the tank, which eliminates noise and vibration while driving
- Empty float height and float retention set for a correct gas gauge reading
- Designed for fast pressure performance with less energy use
- Reduced amperage draw puts less load on the vehicle's electrical system
Quick facts
- Part: Delphi HP10268 fuel pump hanger
- Also called: fuel pump hanger assembly
- Fits: 1992 Buick Park Avenue V6 3.8L and other vehicles
- Condition: New
Hard starting, stalling or a gas gauge that reads wrong can mean the fuel pump hanger assembly needs attention. Those signs can also come from other fuel system parts, so confirm the cause first; a shop can run a fuel pressure test, which needs the engine running.
Fits
This hanger fits the 1992 Buick Park Avenue V6 3.8L, the 1992 Oldsmobile 98 V6 3.8L and the 1984-1987 Buick Regal V6 3.8L, and each takes one. It is a direct-fit replacement for these vehicles.
Specifications
Fit and size
- Quantity per vehicle: 1
- Engine: V6 3.8L
Build and materials
- Condition: New
- Fuel tubes: metal
In the box
One fuel pump hanger with float arm, lock ring, seal and instruction sheet.
Installation notes
- Check and clean the fuel tank before fitting the new hanger.
- The instruction sheet in the box covers the steps.
Interchange: 4017213 · CHP10268 · 25092108 · FG156A
This part cross-references / interchanges with the following part numbers:
4017213, CHP10268, 25092108, FG156A
Frequently Asked Questions
Does the Delphi HP10268 fuel pump hanger fit the 1984-1987 Buick Regal V6 3.8L?
Yes. Delphi HP10268 fits the 1984-1987 Buick Regal V6 3.8L, and each of these cars takes one hanger.
Does this fuel pump hanger come with a float arm and lock ring?
Yes. The hanger comes with its float arm, lock ring, seal and an instruction sheet.
Will this hanger give a correct gas gauge reading?
The empty float height and float retention are matched to OE specifications, which is meant to give a correct gas gauge reading.
Will the metal tubes on this Delphi hanger rattle against the fuel tank?
No. The metal tubes are routed so they never touch the tank at any point, which eliminates noise and vibration during driving.
Does the tank need cleaning before I install the Delphi HP10268?
Yes. Check and clean the fuel tank first when fitting Delphi HP10268. The instruction sheet in the box gives the installation steps.
