Delphi HP10270 fuel pump hanger for the 1986-1987 Ford E-350 Econoline V8 7.5L and other vehicles holds the pump in the fuel tank and carries the float arm. Also called a fuel pump hanger assembly, it has a float arm that lets the gas gauge read the tank level.
- Metal tubes routed so they never touch the tank, which eliminates noise and vibration during operation
- Empty float height and float retention set for a correct gas gauge reading
- Designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw, so less load on the vehicle's electrical system
- Validated, tested and matched to the right vehicle application
Quick facts
- Part: Delphi HP10270 fuel pump hanger
- Also called: fuel pump hanger assembly
- Fits: 1986-1987 Ford E-350 Econoline V8 7.5L and other vehicles
- Condition: New
A gas gauge that reads wrong or jumps around, hard starting or a noisy tank can mean the hanger is worn. If the hanger is the cause, this part replaces it. These signs alone do not prove the hanger is at fault, since a clogged fuel filter is another common cause.
Fits
The 1986-1987 Ford E-350 Econoline V8-7.5L takes one, and the same part fits the 1986-1987 Ford E-350 Econoline Club Wagon V8-7.5L. Both models are also covered in 1991 with the V8-7.5L, V8-5.8L or L6-4.9L engine.
Specifications
- Quantity per vehicle: 1
- Condition: New
In the box
One fuel pump hanger with float arm, one seal and one instruction sheet.
Installation notes
- Check and clean the fuel tank before installing the hanger.
- The steps are on the instruction sheet that comes with the part.
Interchange: E6UZ 9H307-F · E6UZ 9H307-FA
4011159 · 4017222 · DHP10270 · P77323S · FG173A · SP2015H
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
4011159, 4017222, DHP10270, P77323S, E6UZ 9H307-F, E6UZ 9H307-FA, FG173A, SP2015H
Frequently Asked Questions
Does the Delphi HP10270 fit a 1986-1987 Ford E-350 Econoline Club Wagon V8-7.5L?
Yes. Delphi HP10270 fits the 1986-1987 Ford E-350 Econoline Club Wagon V8-7.5L, and that vehicle takes one.
Does this fuel pump hanger come with the float arm and a seal?
Yes. Delphi HP10270 comes with the float arm, a seal and an instruction sheet.
Is the float on the HP10270 set up for an accurate gas gauge?
Yes. Empty float height and float retention match OE specifications, which is meant to give a correct gas gauge reading.
Should I do anything to the fuel tank before installing this hanger?
Yes. Check and clean the fuel tank before installing the hanger. The instruction sheet in the box covers the steps.
Does the Delphi HP10270 replace the E6UZ 9H307-F number?
Yes. E6UZ 9H307-F is one of the numbers Delphi HP10270 replaces.
