Delphi FG1177 fuel pump module for the 2008-2010 BMW 528i 6-cylinder 3.0L and other vehicles sends fuel from the tank to the engine. This Delphi fuel pump module assembly is built to Delphi's OE standards.
- Empty float height and float retention match the specification for a correct gas gauge reading
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated and tested, then matched to the right vehicle application
- Fuel pump module design and durability for lower failure rates
Quick facts
- Part: Delphi FG1177 fuel pump module
- Also called: fuel pump assembly
- Fits: 2008-2010 BMW 528i 6-cylinder 3.0L and other vehicles
- Condition: New
Hard starting, stalling or a gas gauge that reads wrong can mean the fuel pump module is failing, but a blown fuse or a bad relay can produce those symptoms too. Before replacing it, look over the fuel pump fuse and relay with the ignition off; a shop can test fuel pressure.
Fits
This fuel pump module is a direct-fit replacement for the 2008-2010 BMW 528i 6-cylinder 3.0L, the 2008-2010 BMW 550i V8 4.8L and the 2009-2010 BMW 528i xDrive 6-cylinder 3.0L, and each takes one. It fits more than these, so open the "Vehicles it fits" section to check your exact model and engine.
Specifications
- Quantity per vehicle: 1
- Engines: L6-3.0L, V8-4.8L
- Condition: New
In the box
One fuel pump module. The float arm, seals and instruction sheet are not included.
Installation notes
- Check and clean the fuel tank before fitting the module.
Interchange: 16 11 7 373 503 · 16 14 6 766 150
4010589 · E8687M · FFG1177 · 66157 · 69840 · P76875M · A33203 · SP5093M · USEP8687M
This part cross-references / interchanges with the following part numbers:
4010589, E8687M, FFG1177, 16 11 7 373 503, 16 14 6 766 150, 66157, 69840, P76875M, A33203, SP5093M, USEP8687M
Frequently Asked Questions
Will the Delphi module fit the 2009-2010 BMW 528i xDrive 6-cylinder 3.0L?
Yes. Delphi FG1177 is listed for the 2009-2010 BMW 528i xDrive 6-cylinder 3.0L, and that car takes one module.
Does the Delphi fuel module come with a float arm and seals?
No. This fuel pump module comes without a float arm, seals or an instruction sheet, so those are not part of the listing.
Which engines is this fuel pump assembly listed for?
The L6-3.0L and V8-4.8L. Open the "Vehicles it fits" section to match your exact model and year to the right engine.
Does this module help the gas gauge read correctly?
Its empty float height and float retention match OE specifications, which is intended to give a correct gas gauge reading.
Should I clean the fuel tank before installing Delphi FG1177?
Yes. Check and clean the fuel tank before the Delphi FG1177 goes in. Because the job involves the fuel system, a shop can handle it.
