Keep the steering tight and the front suspension properly located with the Delphi ball joint TC632, a front lower suspension ball joint built with Delphi's OE expertise. It's a direct-fit replacement for the 1986-1989 Toyota Celica, so if a worn front lower joint is behind your loose or noisy front end, this drops in as the replacement.
Delphi applies the same OE safety technology fitted to millions of vehicles worldwide, testing to the extreme for OE performance — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with extensive dimensional and material analysis for the best OE-to-aftermarket compatibility.
- High-quality forgings: for increased strength and smooth operation.
- Chloroprene rubber boot: improves durability and helps prevent premature failure.
- Micron-tolerance machining: for durable, smooth joint operation.
- Anti-corrosion protection: applied to each part for corrosion prevention and enhanced aesthetics.
A worn ball joint can show up as clunking over the front suspension, wandering steering, or uneven tire wear; if the front lower joint is the cause, replacing it addresses those signs. It's a safety-critical part, so have your alignment checked after installation.
Interchange: 101-4723 · 43330-29145
1014723 · 4333029145 · BJ07062 · B9387 · B9387PR · K9387 · GK9387 · MK9387 · MS8081 · MS9805 · JBJ215 · JBJ219 · 4333029146 · 4333029185
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
101-4723, BJ07062, B9387, B9387PR, K9387, GK9387, MK9387, MS8081, MS9805, JBJ215, JBJ219, 43330-29145, 4333029146, 4333029185
Frequently Asked Questions
Is this ball joint a direct fit for the 1986-1989 Toyota Celica?
It's a direct-fit front lower ball joint for the 1986-1989 Toyota Celica. See the "Vehicles it fits" section to confirm the exact fit for your vehicle.
What position on the vehicle does this ball joint replace?
This is a front lower ball joint. It helps locate the front suspension and allows the control arm to pivot with steering and suspension travel.
What are the signs a ball joint may need replacing?
Common signs include clunking over the front suspension, wandering or loose steering, and uneven front tire wear. Diagnose the cause before replacing.
What is the boot made of?
It uses a chloroprene rubber boot, which improves durability and helps prevent premature failure by protecting the joint from contamination.
Should I get an alignment after installing this part?
Yes. Because a ball joint affects front suspension geometry, having a wheel alignment checked after installation is recommended for even tire wear.
