Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2066
$109.99
(You save)
Steer with confidence and keep your suspension geometry in check with the Delphi control arm and ball joint assembly (P/N: TC2066), a direct-fit replacement for the front right lower rearward position on the 2000-2006 BMW X5. If a worn arm or ball joint on your 2000-2006 BMW X5 is the cause of clunks, uneven tire wear, or vague steering, this assembly replaces it — the arm locates the wheel and the integrated ball joint allows steering and suspension travel.
Delphi applies its OE expertise to the aftermarket steering portfolio, and this 2000-2006 BMW X5 lower control arm is built and tested to demanding standards:
Extreme testing: validated below -40°C and above 120°C, plus 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Flaw detection: 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision studs: ball studs machined to micron tolerances for durability and smooth joint operation.
Robot welding & coating: consistent welds plus anti-corrosion protection for corrosion prevention and enhanced aesthetics.
Sold individually for the front right lower rearward corner.
It is a direct-fit replacement for the front right lower rearward position on the 2000-2006 BMW X5. See the Buyer's Guide tab to confirm your exact engine and configuration.
Where does this control arm mount?
It installs in the front right lower rearward position. It locates the wheel and its integrated ball joint allows steering and suspension movement.
What are signs this control arm may need replacing?
Clunks over bumps, uneven tire wear, or vague, wandering steering can be signs of a worn arm or ball joint. Have the cause diagnosed before replacing.
How is this part tested for quality?
Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and runs 100% crack and ultrasonic flaw detection so materials match OE specifications.
Do I need to replace both sides?
This listing is for one assembly for the front right lower rearward corner. Inspect the opposite side and replace as your service procedure directs for balanced handling.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2066
Help keep the front wheel properly located with the Delphi control arm and ball joint assembly (P/N: TC1666), a direct-fit front left upper unit for the 1989-1997 Ford Thunderbird and 1989-1997...
Help restore steady handling up front with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC5343. This front left upper control arm and ball joint assembly drops in as a...
Fit your Delphi control arm with confidence: the Delphi Suspension Control Arm and Ball Joint Assembly TC5428 mounts in the front right upper position and locates the wheel while the integrated ball...
Tighten up your front suspension with the DELPHI control arm TC6252, a Suspension Control Arm and Ball Joint Assembly that installs as the front right lower forward unit and drops in as a direct-fit...
Keep your front suspension located precisely and your ball joint working smoothly with the DELPHI control arm (MPN TC6275), a front right lower control arm and ball joint assembly engineered as a...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
