Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3238
$241.99
(You save)
Keep your front suspension tight and precisely located with the Delphi control arm (TC3238), a front right lower unit built as a direct-fit replacement for the 2001-2006 Mitsubishi Montero. This control arm and ball joint assembly locates the wheel and lets the integrated ball joint pivot for suspension travel and steering movement — if a worn arm or ball joint is behind clunking on acceleration or braking, loose steering, or uneven tire wear, this assembly replaces both as one unit.
OE-derived engineering: Delphi applies its OE steering expertise to this aftermarket arm, testing to withstand temperatures below -40°C and over 120°C plus 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified integrity: Each control arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Machined ball studs: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Construction and finish: Robot welding provides consistent quality, and anti-corrosion protection is applied for corrosion prevention and enhanced appearance.
Shopping for a 2001-2006 Mitsubishi Montero control arm? See the Buyer's Guide tab for the full application details.
What vehicle does the Delphi TC3238 control arm fit?
It is a direct-fit replacement for the 2001-2006 Mitsubishi Montero. See the Buyer's Guide tab to confirm the correct application for your vehicle.
What position is this control arm?
This is the front right lower control arm with an integrated ball joint. It replaces the original arm and ball joint as one assembly.
What does this front control arm do?
It locates the wheel and, through the integrated ball joint, allows suspension travel and steering movement while maintaining a solid connection to the chassis.
What are signs this control arm may need replacing?
Clunking on acceleration, braking, or over bumps, loose or wandering steering, and uneven tire wear can indicate a worn arm or ball joint. Diagnose the cause before replacing.
How is the Delphi arm protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance, and Delphi tests its arms through 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3238
Help maintain precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position...
Help restore steering precision and confident wheel control with the Delphi control arm and ball joint assembly (P/N: TC5901), a direct-fit replacement for the front left upper position on the...
Steer with confidence and keep your front suspension tight with the Delphi control arm and ball joint assembly (P/N: TC6247). This is the front left upper unit, dropping in as a direct-fit...
Help keep your steering precise and your ride stable with the Delphi control arm and ball joint assembly (P/N: TC1393), a direct-fit replacement for the front right lower rearward position on the...
Help restore steady front-end control on your Audi with the Delphi control arm and ball joint assembly (TC2455) — a Delphi control arm that installs as a front right lower rearward, direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
