Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3280
$151.99
(You save)
Help restore a solid front-end feel and steering response with the Delphi control arm, part number TC3280 — a front right lower control arm and ball joint assembly backed by Delphi's OE expertise and fitted as a direct-fit replacement for the 2006-2011 Toyota RAV4. This assembly locates the wheel, allows suspension travel, and provides the pivot point for steering, so a worn or damaged original can be swapped out in one part.
OE-level durability testing: Delphi tests to the extreme, with parts that withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, plus dimensional and material analysis for close OE-to-aftermarket compatibility.
100% inspection: Every control arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: Robot welding gives consistent quality, and anti-corrosion protection is applied for corrosion prevention and enhanced aesthetics.
It installs in the front right position as a 2006-2011 Toyota RAV4 lower control arm. See the Buyer's Guide tab for engine-level fitment on the listed applications.
What is the Delphi TC3280 control arm with ball joint?
It is a front right lower suspension component that combines the control arm and its integrated ball joint into one assembly, locating the wheel and providing the steering pivot point.
Is this the right control arm for a 2006-2011 Toyota RAV4?
It is a direct-fit replacement for the 2006-2011 Toyota RAV4. Check the Buyer's Guide tab to confirm engine-level fitment for your specific vehicle.
What position on the vehicle does this control arm cover?
This is the front right (passenger-side) lower control arm with ball joint. It is sold individually for one side; the left side is a separate part, and replacing both sides together is recommended.
What are signs this control arm may need replacing?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can be signs of a worn control arm or ball joint. Diagnose the cause before replacing.
Which part numbers does the TC3280 replace?
It interchanges with numbers including 102-6850, 521-250, 524-478, 48068-0R010, 48068-42050, 48068-42051, KSC6040, CB74214, CK620587, MS86198 and JTC2579, among others listed above.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3280
Help maintain precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position...
Help restore steering precision and confident wheel control with the Delphi control arm and ball joint assembly (P/N: TC5901), a direct-fit replacement for the front left upper position on the...
Steer with confidence and keep your front suspension tight with the Delphi control arm and ball joint assembly (P/N: TC6247). This is the front left upper unit, dropping in as a direct-fit...
Help keep your steering precise and your ride stable with the Delphi control arm and ball joint assembly (P/N: TC1393), a direct-fit replacement for the front right lower rearward position on the...
Help restore steady front-end control on your Audi with the Delphi control arm and ball joint assembly (TC2455) — a Delphi control arm that installs as a front right lower rearward, direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
