Delphi TC552 front right lower control arm with ball joint for the 1998-2002 BMW Z3 and other vehicles links the wheel to the chassis and pivots at the ball joint. This control arm and ball joint assembly keeps the wheel located as the suspension moves, and its materials are checked to match OE specifications.
- Tested to temperatures below -40 degrees C and over 120 degrees C, and exposed to 720 hours of salt spray
- 100% crack detection and ultrasonic flaw detection on every Delphi control arm
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot-welded control arm for consistent performance and quality
- Anti-corrosion protection applied to each part
Quick facts
- Part: Delphi TC552 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 1998-2002 BMW Z3 and other vehicles
- Position: Front right lower
- Condition: New
A clunk over bumps, uneven tire wear or loose, wandering steering can mean a worn control arm or ball joint. Before you replace this arm, rule out worn sway bar links, tie rods and strut mounts, which can make similar noises.
Fits
This front right lower arm is a direct-fit replacement for the 1998-2002 BMW Z3, the 1992-1999 BMW 318i and the 1992-1999 BMW 318is, among other BMW models. The front axle takes one arm on each side; this listing is the right one, the left is a separate part, and the pair is normally replaced at the same time. If your BMW is not named here, look up its year and model in the "Vehicles it fits" section.
Specifications
Fit and size
- Position: Front right lower
- Quantity per application: 1
Build and materials
- Type: control arm with ball joint
- Construction: robot welded
- Ball studs: machined to micron tolerances
- Finish: anti-corrosion protection on each part
- Condition: New
This part cross-references / interchanges with the following part numbers:
3112 1094 276, 3112 1136 530, 3112 1140 400, 3112 1140 958, 31122339996, 3112 6758 514, 3112 6758 516, 101-5395, 102-5395, 622.34066, 520-740, CB14024, CB14024PR, CK80532, K80532, RK80532, FA4319, CMK80532, CMK9627, CMS101410, GK80532, MK80532
Frequently Asked Questions
Does Delphi TC552 work as a BMW Z3 control arm for the 1998-2002 model years?
Yes. Delphi TC552 is a front right lower control arm with ball joint for the 1998-2002 BMW Z3. Other BMW models are covered too; look yours up in the "Vehicles it fits" section.
Is the TC552 a BMW 318i control arm for the 1992-1999 model years?
Yes. This front right lower arm fits the 1992-1999 BMW 318i and the 1992-1999 BMW 318is.
Which side of the car does the Delphi TC552 go on?
Delphi TC552 is the front right lower arm. The left side of the front axle takes a separate part.
How are the ball studs on this lower control arm made?
Micron-tolerance machining of the ball studs is meant to give durability and smooth joint operation. The arm itself is robot welded for consistent performance and quality.
Is the Delphi TC552 tested for corrosion and temperature extremes?
Yes. Delphi TC552 parts withstand temperatures below -40 degrees C and over 120 degrees C and are exposed to 720 hours of salt spray. Each part also gets anti-corrosion protection.
