Delphi TC7366 front left upper control arm with ball joint for the 2008-2014 Cadillac CTS links the steering knuckle to the body. This Delphi control arm is also called a control arm and ball joint assembly.
- 100% crack detection and ultrasonic flaw detection on the control arms
- Ball studs machined to micron tolerances for smooth joint operation
- Robot-welded control arm for consistent quality
- Anti-corrosion protection applied to each part
- Tested below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray
Quick facts
- Part: Delphi TC7366 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2008-2014 Cadillac CTS
- Position: Front left upper
- Condition: New
A clunk over bumps, uneven tire wear or loose steering can mean this arm or its ball joint is worn, though a tired strut mount or tie rod end can produce similar signs, so find the cause before replacing anything.
Fits
This is a Cadillac CTS control arm for the 2008-2014 model years. This listing is one arm for the front left; the front right upper arm is a separate part, and that axle's pair is normally done at the same time.
Specifications
Fit and size
- Position: front left upper
- Quantity: 1 for the front left
Build and materials
- Construction: robot-welded control arm with ball joint
- Ball studs: machined to micron tolerances
- Finish: anti-corrosion protection
- Condition: new
In the box
One front left upper control arm with its ball joint. The front left takes one, and the front right is ordered separately.
Interchange: 15219467 · CMS501219
Frequently Asked Questions
Is the Delphi TC7366 the right front left upper arm for the 2008-2014 Cadillac CTS?
Yes. Delphi TC7366 is the front left upper control arm with ball joint for the 2008-2014 Cadillac CTS. The right side is a separate part.
Does this front left upper arm include the ball joint?
Yes. This listing is one control arm with its ball joint attached. This side takes one, and the opposite side is ordered separately.
How is the ball stud on this arm made?
Delphi TC7366 has ball studs machined to micron tolerances for smooth joint operation. The arm itself is robot-welded and has anti-corrosion protection.
Why does my front left suspension clunk over bumps?
A clunk over bumps can mean a worn upper control arm or ball joint, though other suspension parts can make the same noise. A shop can inspect the joint for play.
How is the TC7366 tested for rust and temperature?
Delphi TC7366 is tested below -40 degrees C and over 120 degrees C and exposed to 720 hours of salt spray. Each arm also gets 100% crack and ultrasonic flaw detection.
