Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC766
$75.99
(You save)
Bring precise handling back to your Volkswagen's front suspension with the Delphi control arm and ball joint assembly (P/N TC766). This front left lower unit drops in as a direct-fit replacement for the 1995-2002 Volkswagen Cabrio, 1992-1998 Volkswagen Golf, and 1993-1998 Volkswagen Jetta — see the Buyer's Guide tab for engine-level fitment.
Delphi applies its OE expertise to this unit, drawing on safety technology fitted to millions of vehicles worldwide:
Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection confirm the materials match OE specifications.
Precision ball stud: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded and protected: robotic welding delivers consistent quality, and anti-corrosion protection is applied to each part.
The lower control arm locates the wheel while its integrated ball joint lets the suspension pivot as the wheel travels and steers. Signs this part may need replacing include clunking over bumps, wandering or loose steering, and uneven front tire wear; diagnose the cause before replacing.
It's the front left lower unit for the 1993-1998 Volkswagen Jetta, plus the 1995-2002 Cabrio and 1992-1998 Golf. Check the Buyer's Guide tab for engine-level fitment.
What position is this assembly?
It is the front left (driver's side) lower control arm with an integrated ball joint.
Is the ball joint included?
Yes. The ball joint is integrated into this assembly, so you replace the control arm and ball joint together as a single unit.
What are the signs my control arm or ball joint may need replacing?
Common signs include clunking over bumps, wandering or loose steering, and uneven front tire wear. Have the cause diagnosed before replacing.
Does this Golf control arm fit, and should I replace both sides?
Yes, it fits the 1992-1998 Volkswagen Golf. It's the front left unit; replacing the left and right control arms together is good practice for balanced front suspension, though not required.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC766
Sharpen steering response and quiet worn-suspension clunks with the Delphi Suspension Control Arm and Ball Joint Assembly (TC1755) — a front left upper Ford Fusion control arm built to Delphi's OE...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
