Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8189
$211.99
(You save)
Sharpen steering response and settle the ride with the Delphi Suspension Control Arm and Ball Joint Assembly (TC8189) — a front left lower Nissan Altima control arm that installs as a direct-fit replacement on the 2015-2018 Nissan Altima and 2016-2023 Nissan Maxima. This control arm and ball joint assembly locates and supports the front left lower suspension, and its integrated ball joint lets the steering knuckle pivot and travel smoothly.
Extreme-condition tested: withstands temperatures below -40°C and above 120°C plus 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
OE-matched materials: 100% crack detection and ultrasonic flaw detection confirm the materials meet OE specifications.
Precision ball studs: machined to micron tolerances for durable, smooth joint operation.
Built for consistency: robot-welded for repeatable quality, with anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
Signs the original may need replacing include clunking over bumps, loose or wandering steering, and uneven tire wear; if a failed lower control arm or ball joint is the cause, this Delphi control arm replaces it. A popular lower control arm Nissan Altima and Nissan Maxima control arm fix.
What vehicles does the Delphi TC8189 control arm fit?
It is a direct-fit replacement for the 2015-2018 Nissan Altima and 2016-2023 Nissan Maxima. See the Buyer's Guide tab to confirm the engine and options for your vehicle.
Where is this control arm located on the vehicle?
This is the front left (driver-side) lower control arm. The right side is a separate part number, so order accordingly.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into the assembly, so you replace the control arm and its ball joint together as one unit.
What are signs my lower control arm or ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Have the suspension diagnosed to confirm the cause before replacing parts.
How is this Delphi control arm built for durability?
It undergoes 100% crack and ultrasonic flaw detection to meet OE specs, uses ball studs machined to micron tolerances, is robot-welded, and has anti-corrosion protection applied.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8189
Keep your front suspension located and your steering geometry tight with the Delphi control arm, MPN TC2044 — a front right upper forward control arm and ball joint assembly built with Delphi's OE...
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
