Delphi TC882 front right lower control arm with ball joint for the 2001-2002 BMW 325Ci and other vehicles links the wheel to the frame and lets it pivot. This Delphi control arm has the ball joint attached.
- Withstands temperatures below -40 °C and over 120 °C and 720 hours of salt spray
- 100% crack detection and ultrasonic flaw detection on every control arm to check the materials
- Ball studs machined to micron tolerances for durable, smooth joint operation
- Robot-welded arm for consistent performance and quality
- Anti-corrosion protection on each part for corrosion prevention and enhanced appearance
Quick facts
- Part: Delphi TC882 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2001-2002 BMW 325Ci and other vehicles
- Position: Front right lower
- Condition: New
Worn tie rod ends, sway bar links or struts can produce clunks and loose steering too, so find out what is actually causing the problem before you buy. A worn lower control arm or ball joint can show up as a clunk over bumps or steering that feels loose. If the arm or joint is the cause, this assembly replaces both.
Fits
This part fits the 2001-2002 BMW 325Ci, the 2000 BMW 323Ci and the 2000 BMW 323i, and each takes one for the front right lower position. This listing is a single control arm and ball joint assembly; the left side is its own part, ordered separately, and the two sides are normally replaced together.
Specifications
Fit and size
- Position: Front right lower
- Quantity: 1 (front right side only)
Build and materials
- Construction: robot-welded control arm with ball joint
- Ball studs: machined to micron tolerances
- Finish: anti-corrosion protection on each part
- Condition: New
Frequently Asked Questions
Is this control arm right for the 2000 BMW 323i?
Is TC882 a 2001-2002 BMW 325Ci control arm for the front right?
Yes. Delphi TC882 fits the 2001-2002 BMW 325Ci in the front right lower position, with the ball joint already attached to the arm.
Are the ball studs on this Delphi control arm machined to a set tolerance?
Yes. The ball studs are machined to micron tolerances for durable, smooth joint operation, and every control arm gets 100% crack detection and ultrasonic flaw detection.
How can I tell if the ball joint on this lower control arm is worn?
You may notice uneven front tire wear or steering that wanders. Checking the joint for play means raising the vehicle, so have a shop do it.
How is this Delphi control arm protected against rust?
Anti-corrosion protection is applied to each part. The arms also withstand temperatures below -40 °C and over 120 °C and 720 hours of salt spray.
This part cross-references / interchanges with the following part numbers:
3112 1094 466, 3112 6750 224, 31126751318, 3112 6752 718, 3112 6758 520, 3112 6770 248, 31 12 6 774 820, 3112 6777 852, 101-5108, 102-5108, BW-H107, 520-920, CB14044, CK80528, RK80528, FA4406, CMK80528, GK80528, MK80528, 507-1303, JTC1070, JTC962
