Keep your BMW's suspension tight and quiet with the Delphi Suspension Control Arm Link (TC3013). This link connects the rear arm to the knuckle in the lower-front position, and it drops in as a direct-fit replacement for the 2011-2018 BMW X5 and 2008-2019 BMW X6 (see the Buyer's Guide tab for the full engine-level list).
Delphi applies its OE engineering to its aftermarket steering and suspension portfolio, with extensive dimensional and material analysis to keep the aftermarket part close to the original.
Ultrasonic molding: built with ultrasonic molding to help prevent future weld breakage.
Fatigue tested: control arm links are fatigue tested to help avoid failure.
100% inspected: each link undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
OE standards: designed to OE standards, and Delphi validates parts from below -40°C to over 120°C with 720 hours of salt-spray exposure.
A worn control arm link can show up as clunking or knocking over bumps, loose or imprecise handling, or uneven tire wear. If a failed link is the cause, this replaces it. Replace links in pairs for balanced suspension response.
This part cross-references / interchanges with the following part numbers:
33326774476, LL14605, LL4605PR, RK643044
Frequently Asked Questions
What position does this link fit?
It fits the rear arm to knuckle location in the lower-front position on the listed applications. Confirm fitment for your vehicle in the Buyer's Guide.
Which vehicles does the TC3013 fit?
It is a direct-fit replacement for the 2011-2018 BMW X5 and 2008-2019 BMW X6. See the Buyer's Guide tab for the full engine-level list.
What are signs this link may need replacing?
Clunking or knocking over bumps, loose or imprecise steering feel, and uneven tire wear can all point to a worn link. Diagnose the cause before replacing.
Should I replace both links at once?
Replacing links in pairs is recommended so both sides wear evenly and the suspension responds consistently, though this listing is for one link.
How is this Delphi link built for durability?
It uses ultrasonic molding to help prevent weld breakage, is fatigue tested, and undergoes 100% crack and ultrasonic flaw detection to match OE material specifications.
Suspension Control Arm LinkDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the...
Suspension Control Arm LinkDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
