Dorman - First Stop Brake Master Cylinder P/N:M390233
The Dorman - First Stop Brake Master Cylinder M630001 is the part that turns pedal effort into hydraulic pressure for the brakes at every wheel. It is a direct-fit replacement for the 2004-2008 Ford F-150, the 2004-2006 Ford Lobo and the 2006-2008 Lincoln Mark LT. See the Buyer's Guide tab for engine details.
This Dorman brake master cylinder is precision-engineered to mirror the original unit's design, function and performance on the listed trucks. It is built from new, high-quality materials for a safe, durable replacement.
Signs a master cylinder may need replacing include a soft or spongy pedal, a pedal that slowly sinks under steady pressure, a dropping fluid level, and fluid seeping from the cylinder. If a worn master cylinder is causing the problem, this unit replaces it. Other brake faults can produce similar symptoms, so diagnose the cause before ordering. Bench-bleed the new cylinder and bleed the brake system as the vehicle service information directs.
Interchange: 100-2946 · 13-3084 · 10-3084 · 130.65084 · 130.65089 · 130.65090 · 131.65089 · 131.65090 · 355-54200 · 355-54205 · 355-54206 · BRMC-36
1002946 · 133084 · 103084 · 13065084 · 13065089 · 13065090 · 13165089 · 13165090 · 35554200 · 35554205 · 35554206 · BRMC36 · 13913 · 4L3Z2140AB · 4L3Z2140AC · 6L3Z2140A · 7L3Z2140A · M4148 · NM4148 · MC390811 · F141129 · MC141129
This part cross-references / interchanges with the following part numbers:
Will this brake master cylinder fit my 2004-2008 Ford F-150?
The M630001 is listed for the 2004-2008 Ford F-150, the 2004-2006 Ford Lobo and the 2006-2008 Lincoln Mark LT. See the Buyer's Guide tab for engine-level application details.
What are the rubber components made of?
All rubber components are made of a high-quality EPDM compound, which resists glycol-based brake fluid.
What standards is the M630001 built to?
It is made to meet rigorous SAE International standards. Its housing is constructed to match the casting material of the original part.
What are signs a master cylinder may need replacing?
A soft or sinking pedal, a dropping fluid level or fluid seeping from the cylinder can be signs. Other brake faults cause similar symptoms, so diagnose the cause before replacing the cylinder.
Does a new master cylinder need to be bled?
Yes. A master cylinder is normally bench-bled before installation and the brake system bled afterward, following the vehicle service information for the correct procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.