Replace a worn arm and ball joint in one job with this Dorman control arm, part number 520-890, which comes with the ball joint and bushings already installed. It fits many vehicles, including the 2006-2012 Ford Fusion, 2007-2012 Lincoln MKZ and 2006-2011 Mercury Milan, where it serves the front right lower rearward position. See the "Vehicles it fits" section for the full list.
Dorman - OE Solutions builds this suspension control arm and ball joint assembly as a direct replacement for the original assembly on the listed applications. It links the wheel to the chassis and pivots as the suspension moves.
- Direct replacement: built to take the place of the original assembly on the listed applications.
- Complete repair: the ball joint and bushings come pre-installed, saving time and labor.
- Tested design: went through an industry-leading evaluation process intended to deliver a smooth ride, directional stability and predictable dynamics.
- Corrosion protection: additional coatings help resist rust and corrosion.
Signs this part may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear, visible play in the ball joint, and torn bushings. If a worn arm, ball joint or bushing is the cause, this unit replaces all three at once. For a 2006-2012 Ford Fusion lower control arm in the front right rearward location, it is a direct-fit option. Check the vehicle service information for the correct fasteners, torque values and whether the original fasteners may be reused. Have the wheel alignment checked after installation.
Frequently Asked Questions
Is this the right 2006-2012 Ford Fusion control arm?
Yes. Part 520-890 is listed for the 2006-2012 Ford Fusion in the front right lower rearward position. Check the "Vehicles it fits" section to confirm your exact vehicle.
Does it also fit the 2007-2012 Lincoln MKZ or 2006-2011 Mercury Milan?
It is listed for the 2007-2012 Lincoln MKZ and the 2006-2011 Mercury Milan, along with other vehicles shown in the "Vehicles it fits" section.
What comes pre-installed on this control arm?
The ball joint and bushings are already installed, so the arm, joint and bushings are replaced in one step, saving time and labor.
What are signs the lower control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear, ball joint play or torn bushings can mean a worn arm. Diagnose the cause before replacing any parts.
Do I need an alignment after installing it?
A wheel alignment is recommended after replacing a control arm. Check the vehicle service information for fastener torque values and whether the original fasteners may be reused.
