Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Help keep the front end steady and predictable with the Dorman Control Arm with Ball Joint 524-142, a front right lower 2006-2011 Honda Civic control arm that also fits the 2006-2011 Acura CSX. Dorman built it as a direct replacement for the original assembly on the 2006-2011 Honda Civic and 2006-2011 Acura CSX.
This Dorman suspension control arm and ball joint assembly arrives with the ball joint and bushings already installed, saving time and labor. Each unit went through Dorman's industry-leading evaluation process, which is designed to deliver a smooth ride, directional stability and predictable dynamics.
Signs this part may need replacing include clunking or knocking over bumps, a loose or wandering steering feel, and uneven tire wear. These symptoms can have other causes, so inspect the suspension before ordering. This listing is for one right-side arm; replacing both sides together is recommended for balanced handling. Consult the vehicle service information for the correct fasteners and torque values and whether the original hardware may be reused, and have the wheel alignment checked after installation.
Interchange: 102-5293 · 810-233824B
1025293 · 810233824B · TC2923 · CA12681 · 51220SNAA02 · 51220SNAA03 · 51350SNAA03 · 5CB60079 · CK620383 · RK620383 · GS60101 · CMS60101 · 2605713 · 2605713M · X620383 · SRK620383 · X17CA0646 · X17CJ0645
This part cross-references / interchanges with the following part numbers:
Will this control arm fit a 2008 Honda Civic?
Yes. The 524-142 is listed for the 2006-2011 Honda Civic, which includes 2008, and installs in the front right lower position.
Is this 2006-2011 Honda Civic lower control arm for the left or right side?
It is the front right lower arm, sold individually. Replacing both sides together is recommended for balanced handling.
What comes with the assembly?
Each assembly includes a pre-installed ball joint and bushings. Consult the vehicle service information for the correct fasteners and whether the originals may be reused.
What are signs a control arm with ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering and uneven tire wear. These can have other causes, so diagnose the suspension before replacing parts.
Is the Dorman control arm protected against rust?
Yes. Dorman applies additional coatings to this part for rust and corrosion resistance.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.