Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-510
$73.99
(You save)
Keep your Audi's front suspension precisely located with the Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly 524-510. This front right upper forward assembly is a direct-fit replacement for the 2012-2015 Audi A6, 2012-2015 Audi A6 Quattro, 2012-2015 Audi A7 Quattro, 2013-2015 Audi Allroad, 2014-2015 Audi RS7, and 2013-2015 Audi S6 (All engines). The control arm positions the wheel while the integrated ball joint lets the suspension and steering move through their travel; worn bushings or a loose ball joint often show up as clunks, uneven tire wear, or a wandering feel.
Complete repair: ships with the ball joint and rubber bushings pre-installed, saving time and labor.
Cast/forged aluminum arm: finished in black with additional coatings for rust and corrosion resistance.
Pre-greased: uses a pinch-type ball joint stud with a 14 mm thread diameter; no grease fitting and non-adjustable.
Mounting hardware included to support installation on the listed applications.
Backed by Dorman's industry-leading evaluation testing for a smooth, stable ride, this assembly drops in on the specific vehicle applications above. Country of origin: Taiwan.
This part cross-references / interchanges with the following part numbers:
102-7513, TC2973, CA5258, 2607130
Frequently Asked Questions
Which vehicles does the 524-510 fit?
It fits the 2012-2015 Audi A6, 2012-2015 A6 Quattro, 2012-2015 A7 Quattro, 2013-2015 Allroad, 2014-2015 RS7, and 2013-2015 S6 (All engines). See the Buyer's Guide tab to confirm your vehicle.
What is included with this assembly?
The ball joint and rubber bushings come pre-installed, and mounting hardware is included, so it installs as a complete unit on the listed applications.
Does it have a grease fitting?
No. It is pre-greased and does not include a grease fitting, so there is no separate grease zerk to service.
What position is this assembly for?
It is cataloged as the front right upper forward control arm and ball joint assembly for the listed Audi applications.
Is this control arm adjustable, and what is it made of?
It is non-adjustable and uses a cast/forged aluminum arm finished in black with additional coatings for rust and corrosion resistance.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-510
Suspension Control Arm And Ball Joint AssemblyThis suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
