Dynamic Friction Company Disc Brake Hardware Kit P/N:340-80043

Be the first to review this product
$7.99
MPN: 340-80043
UPC: 190920009297
Item Package Quantity: 1

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-80043
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-80043
$7.99

Keep your front brakes quiet, properly located, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-80043, also written 34080043). This front disc brake hardware kit supplies the clips, springs, and abutment hardware that position the pads and let them slide as the brakes apply and release. It installs on the front axle of the 2017-2020 FIAT 124 Spider and the 2016-2026 Mazda MX-5 Miata — see the Buyer's Guide tab for engine-level details.

  • Corrosion resistance: helps the hardware hold up against rust and road exposure at the caliper.
  • Chemical & high-heat resistance: designed to withstand brake heat and the chemicals present in the brake environment.
  • Low coefficient of friction: allows the pads to move smoothly against the hardware for even pad movement.
  • Easy assembly & removal: intended to speed up pad service and install cleanly during a brake job.

Fresh hardware is best fitted whenever you replace the front pads: worn, rusted, or distorted clips can cause noise, uneven pad wear, or dragging. If tired hardware is behind those signs on your vehicle, this kit replaces it. Refer to the vehicle service information for the correct install procedure.

Frequently Asked Questions

What is included in this kit?

It supplies the disc brake hardware — the clips, springs, and abutment pieces that locate the front pads and allow them to slide as the brakes apply and release. Pads and rotors are not part of a hardware kit.

Which vehicles does the 340-80043 kit fit?

It fits the front axle of the 2017-2020 FIAT 124 Spider and the 2016-2026 Mazda MX-5 Miata. Check the Buyer's Guide tab to confirm your exact vehicle.

Is this front or rear hardware?

This kit is cataloged for the FRONT axle. It provides the front disc brake mounting and anti-rattle hardware for the listed applications.

Should I replace the hardware when I change my brake pads?

Replacing the hardware with new pads is good practice. Worn, rusted, or distorted clips and springs can cause noise, dragging, or uneven pad wear, so fresh hardware helps the new pads seat and move correctly.

Does this hardware resist heat and corrosion?

Yes. The kit is made for corrosion resistance, chemical resistance, and high-heat resistance, with a low coefficient of friction so the pads can move smoothly against the hardware.