Built to deliver steady clamping force at the front left wheel, the Raybestos R-Line remanufactured brake caliper and bracket assembly, part number FRC11425, is a semi-loaded unit that uses hydraulic pressure to press the brake pads against the rotor. It fits many vehicles, among them the 2003-2017 Honda Accord, 2013-2021 Honda Civic and 2013-2014 Honda Fit. See the Buyer's Guide tab for the full list.
Raybestos R-Line non-plated calipers are remanufactured OE parts. All rubber and sealing components are new, the castings, guide pins and brackets are carefully inspected before they are reused, and each caliper is tested for braking performance. Whether you are servicing a 2003-2017 Honda Accord or shopping for a 2013-2021 Honda Civic brake caliper, this disc brake caliper comes with its bracket as one assembly.
Specifications: floating caliper type with a cast iron casting, 57.1 mm (2.248 in) piston diameter, M10x1 bleeder screw thread, and 12.000 mm bracket mounting holes with a 1.250 mm thread pitch. Country of origin: Mexico.
This listing is for one front left caliper and bracket assembly, sold individually. Replacing both front calipers together is recommended for even, balanced braking.
Interchange: 99-00943A · 19-B2660 · 19-P2660 · 141.40078 · 142.40078 · 14-5158
9900943A · 19B2660 · 19P2660 · 14140078 · 14240078 · 145158 · SC3817 · 45019T2FA00 · 45019TEAT00
This part cross-references / interchanges with the following part numbers:
Is this a 2003-2017 Honda Accord caliper for the front left wheel?
Yes. FRC11425 is a front left caliper and bracket assembly for the 2003-2017 Honda Accord. Check the Buyer's Guide tab to confirm your exact vehicle.
Which other popular vehicles does FRC11425 fit?
It also fits the 2013-2021 Honda Civic and the 2013-2014 Honda Fit. Many more vehicles are listed in the Buyer's Guide tab.
What parts are new on this remanufactured caliper?
Raybestos replaces the seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings with new materials. The castings, guide pins and brackets are inspected before they are reused.
What are the key specifications of this caliper?
It is a floating caliper with a cast iron casting and a 57.1 mm (2.248 in) piston. It has an M10x1 bleeder screw thread and 12.000 mm bracket mounting holes with a 1.250 mm thread pitch.
What signs may mean a brake caliper needs replacing?
A pull to one side, fluid leaking at the caliper, uneven pad wear or a dragging brake may be signs of a caliper problem, so diagnose the cause first. The brake system must be bled after installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
