Bring dependable hydraulic clamping force back to the front-left brake with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper and Bracket Assembly (MPN FRC10946). It installs as a direct-fit replacement for the 1998-2005 Chevrolet Blazer, 1998-2004 Chevrolet S10, 1998-2005 GMC Jimmy, 1998-2004 GMC Sonoma, 1998-2000 Isuzu Hombre, and 1998-2001 Oldsmobile Bravada (All engines).
Remanufactured from OE cores: castings, guide pins, and brackets are inspected before reuse, and the seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings are all replaced with new materials for leak-free operation.
Two-piston floating design: a floating caliper with two pistons measuring 1.810 in (45.974 mm), an M10x1.50 bleeder screw thread, and an M14 bracket mounting hole (2 mm pitch).
Built and tested to spec: EPDM70 rubber components for heat resistance, materials that match OE specifications, and 100% pressure testing.
Semi-loaded assembly: includes the mounting bracket in a friction-ready configuration (brake pads not included); cast iron caliper with a non-plated coated finish. Country of origin: Mexico.
Signs a caliper may need attention include fluid seepage at the piston or bleeder, a caliper that sticks or drags, or uneven pad wear; if a failed front-left caliper is the cause, this assembly replaces it.
It's a front-left fit for the 1998-2005 Chevrolet Blazer and GMC Jimmy, 1998-2004 Chevrolet S10 and GMC Sonoma, 1998-2000 Isuzu Hombre, and 1998-2001 Oldsmobile Bravada (all engines). See the Buyer's Guide tab to confirm.
Is this a new or remanufactured caliper?
It's a Raybestos R-Line remanufactured (reman) unit rebuilt from an OE core with all-new seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings, then 100% pressure tested.
Are brake pads included?
No. It's a friction-ready semi-loaded assembly, so the caliper and its mounting bracket are included but brake pads are not. Consult the service procedure for the correct pads.
What are the piston and bleeder details?
The floating caliper uses two pistons measuring 1.810 in (45.974 mm) in diameter, with an M10x1.50 bleeder screw thread.
Should I replace both calipers at once?
Replacing the left and right calipers as a matched pair is a recommended best practice for balanced braking, though not required. This listing is for one front-left caliper.
Bring firm, even clamping back to your front-left brake corner with the Raybestos Element3 New Semi-Loaded Disc Brake Caliper and Bracket Assembly (FRC12213N). This floating-type caliper squeezes the...
Clamp the brake pads against the rotor under hydraulic pressure with the Raybestos Brakes Element3 New Semi-Loaded Disc Brake Caliper & Bracket Assembly, MPN FRC11617N. This front-left floating...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
