Put a freshly remanufactured, pressure-tested caliper back on the front axle with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper, part number FRC11550. This fixed-type caliper presses the brake pads against the rotor when the pedal is applied. It fits many vehicles, among them the 2000-2006 Toyota Tundra, 2003-2005 Toyota 4Runner and 2001-2007 Toyota Sequoia, all engines. See the "Vehicles it fits" section for the full list.
Raybestos R-Line non-plated calipers are remanufactured OE units built with all-new rubber and sealing components, including seals, boots and bleeders. Castings, guide pins and brackets are carefully inspected before they are reused, and each caliper is rigorously tested, with 100% pressure testing.
- New wear components: Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials to help provide leak-free operation.
- OE-matched materials: Materials match OE specifications and meet vehicle-specific designs.
- EPDM70 rubber components: Used for heat resistance, performance and durability.
- Specifications: Fixed caliper type, cast iron casting, 45.4 mm (1.787 in) piston diameter and M7x1 bleeder screw thread.
This caliper is cataloged for the front left and front right positions, and the listed applications use one. It is sold individually. Replacing both front calipers together is recommended for even, balanced braking. Bleed the brake system after installation, and follow the vehicle service information for torque values. Country of origin: Mexico.
Frequently Asked Questions
Is this the right 2000-2006 Toyota Tundra brake caliper?
FRC11550 is listed for the 2000-2006 Toyota Tundra with all engines, and also for the 2003-2005 Toyota 4Runner and 2001-2007 Toyota Sequoia. Use the "Vehicles it fits" section to confirm your vehicle.
Which position does this caliper install in?
It is cataloged for the front left and front right positions. It is sold individually, and replacing both front calipers together is recommended for even, balanced braking.
What are the key specifications of FRC11550?
It is a fixed-type caliper with a cast iron casting, a 45.4 mm (1.787 in) piston diameter and an M7x1 bleeder screw thread. Country of origin: Mexico.
What parts are renewed during remanufacturing?
Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials. Castings, guide pins and brackets are inspected before reuse, and every unit is pressure tested.
What are signs a brake caliper may need replacing?
Common signs include brake fluid leaking at the caliper, pulling to one side when braking, a dragging wheel or uneven pad wear. Diagnose the cause first, and bleed the brakes after installation.
