Raybestos Brakes Disc Brake Caliper P/N:FRC12596
Swap out a leaking or sticking rear right caliper with the Raybestos R-Line remanufactured Brake Caliper FRC12043, a semi-loaded caliper and bracket assembly that clamps the brake pads against the rotor to slow the wheel. It fits many vehicles, among them the 2008-2019 Ford E-350 Super Duty, 2008-2014 Ford E-150 and 2008-2014 Ford E-250, as a direct-fit replacement for the listed applications. See the Buyer's Guide tab for the full list.
Specifications: This is a floating caliper with a cast iron casting, a 1.87 in (47.5 mm) piston diameter and an M10x1 bleeder screw thread. It mounts at the rear right position, and the listed applications use one at that position. Country of origin: Mexico.
A caliper may need replacing if you see brake fluid seeping at the caliper, the vehicle pulls to one side, a wheel drags or runs hot, or pads wear unevenly. Diagnose the cause before replacing, because other brake parts can produce similar symptoms. The caliper is sold individually, and replacing the calipers on both sides of the axle together is recommended for balanced braking. Bleed the brake system after installation, and follow the vehicle service information for fasteners and torque values.
Interchange: 15-13363 · 99-17953A · 18-B5074 · 18-P5074 · 141.65533 · 142.65533 · 10-3363S · 14-3363
1513363 · 9917953A · 18B5074 · 18P5074 · 14165533 · 14265533 · 103363S · 143363 · SC3028 · SC3058 · 8C2Z2552A · BC2Z2552A
This part cross-references / interchanges with the following part numbers:
Is this the right Ford E-250 brake caliper for my van?
It is listed for the rear right position on the 2008-2014 Ford E-250. It also fits the 2008-2019 Ford E-350 Super Duty and the 2008-2014 Ford E-150; check the Buyer's Guide tab for your exact vehicle.
What does a disc brake caliper do?
When you press the pedal, hydraulic pressure pushes the caliper piston, which clamps the brake pads against the rotor to slow the wheel. This floating unit mounts on its bracket at the rear right.
What comes in the box?
One remanufactured semi-loaded caliper with its mounting bracket, for the rear right position. It is sold individually, and replacing the calipers on both sides of the axle together is recommended.
What are the caliper's key specifications?
It is a floating caliper with a cast iron casting, a 1.87 in (47.5 mm) piston diameter and an M10x1 bleeder screw thread. Country of origin: Mexico.
What signs suggest a caliper may need replacing?
Common signs are brake fluid leaking at the caliper, pulling to one side, a dragging or hot wheel, and uneven pad wear. Diagnose the cause first, since other brake parts can cause similar symptoms.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.