Deliver firm hydraulic clamping force at the front brakes with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper and Bracket Assembly (FRC10694). This floating caliper houses the hydraulic piston that squeezes the brake pads against the rotor, and it drops in for the front position of the 1996-2000 Honda Civic, 1997-2000 Acura EL, 2001-2005 Honda Civic, 2002-2004 Honda Civic, 2006-2011 Honda Civic (All and L4-1.8L), and 2010-2014 Honda Insight.
- Remanufactured OE part: rebuilt using all-new rubber and sealing components — seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings — while castings, guide pins, and brackets are inspected before reuse.
- Materials match OE specifications and vehicle-specific designs.
- 100% pressure tested for reliable braking performance.
- EPDM70 rubber components for heat resistance, performance, and durability.
- Specs: floating caliper · 2.122 in (53.9 mm) piston · M10x1 bleeder screw thread · cast iron casting · 12.000 mm bracket mounting holes (1.250 mm pitch).
Calipers work per corner; replacing both front sides together as a matched pair is best practice for balanced braking. Sold individually. Country of origin: Mexico.
Interchange: 19-3449 · 193449 · 19-B1833 · 19B1833 · 19-P1833 · 19P1833 · 141.40043 · 141.40085 · 142.40043 · SC1820 · 45019S5DA00 · 99-00929B · 9900929B
Manufacturer part number FRC10694
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this caliper do?
It's a floating disc brake caliper that houses the hydraulic piston, which clamps the brake pads against the rotor to slow the wheel. This is a remanufactured semi-loaded caliper and bracket assembly.
Which vehicles does it fit?
It's a direct-fit front replacement for the 1996-2000, 2001-2005, 2002-2004, and 2006-2011 Honda Civic (All and L4-1.8L), 1997-2000 Acura EL, and 2010-2014 Honda Insight. See the Buyer's Guide tab.
Is this a front or rear caliper?
The catalog lists it for the front position (left or right). It is sold individually; replacing both front sides together as a matched pair is recommended for even, balanced braking.
What is refreshed during remanufacturing?
The seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings are replaced with new materials, and each unit is 100% pressure tested. EPDM70 rubber components add heat resistance.
What are the caliper's key specs?
It uses a floating design with a 2.122 in (53.9 mm) piston, an M10x1 bleeder screw thread, a cast iron casting, and 12.000 mm bracket mounting holes with a 1.250 mm thread pitch.
Write a Review