Delphi FG2161 fuel pump module for the 2004-2006 Mitsubishi Outlander 4-cylinder 2.4L pumps fuel from the tank to the engine. The Delphi fuel pump module assembly sits inside the fuel tank.
- Empty float height and float retention for a correct gas gauge reading
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated, tested and matched to the right application
- Design and durability for lower failure rates
Quick facts
- Part: Delphi FG2161 fuel pump module
- Also called: fuel pump assembly
- Fits: 2004-2006 Mitsubishi Outlander 4-cylinder 2.4L
- Condition: New
A worn fuel pump module, also called a fuel pump assembly, can show up as hard starting, stalling or a fuel gauge that reads wrong. These signs alone do not prove the module is at fault, since a weak fuel pump relay can also be behind them.
Fits
This fuel pump module fits the 2004-2006 Mitsubishi Outlander 4-cylinder 2.4L, and the vehicle takes one. The module is built to Delphi's OE standards, and its empty float height and float retention match OE specifications.
Specifications
- Quantity per vehicle: 1
- Condition: New
- Empty float height and float retention: match OE specifications
In the box
One fuel pump module. The float arm, seal and instruction sheet are not included.
Installation notes
- Check and clean the fuel tank before installing the module.
Interchange: 4010444 · E8639M · CFG2161 · 67761 · P76389M · A33088 · 1760A094 · MN186025 · C0620M · SP4063M · SP4154M · USEP8639M
This part cross-references / interchanges with the following part numbers:
4010444, E8639M, CFG2161, 67761, P76389M, A33088, 1760A094, MN186025, C0620M, SP4063M, SP4154M, USEP8639M
Frequently Asked Questions
Is the Delphi fuel pump module right for the 2004-2006 Mitsubishi Outlander 4-cylinder 2.4L?
Yes. Delphi FG2161 is listed for the 2004-2006 Mitsubishi Outlander 4-cylinder 2.4L, and that vehicle takes one.
Does the Delphi fuel module come with a float arm?
No. This module comes without the float arm, seal and instruction sheet. The listing is the fuel pump module only.
Does the Delphi module match OE float height for an accurate gas gauge?
Yes. On this fuel pump module, empty float height and float retention match OE specifications for a correct gas gauge reading.
Should the fuel tank be cleaned before installing this fuel pump module?
Yes. The fuel tank should be checked and cleaned before the new Delphi FG2161 module goes in.
Does the Delphi FG2161 replace number E8639M?
Yes. E8639M is one of the interchange numbers listed for this fuel pump module, along with 4010444 and 67761.
